Overview
The Omix-ADA 18670.27 is a rear yoke for the Dana 18 transfer case. It fits Jeep CJ3, CJ5 and CJ6 models from 1959 to 1971 and Willys CJ-2, CJ-3, CJ-5 and CJ-6 models from 1946 to 1958.
It is built to original specifications and carries a limited five year warranty. Check the spline count, yoke size and attachment style against your Dana 18 before installing.
Key features
- Rear yoke position
- Dana 18 transfer case application
- Built to original specifications
- Omix-ADA part number 18670.27
Before you fit a rear yoke
A rear yoke sits on the output shaft at the back of the transfer case and holds the rear driveshaft. Because it carries the driveshaft’s torque and the angle of the U-joints, it wears at the splines and seal area over time. Replacement is usually needed when the yoke shows play, scoring or leakage at the seal.
When choosing a replacement, the transfer case model matters more than the vehicle year alone, since the yoke has to match the output shaft. Many owners replace the output seal at the same time and inspect the driveshaft U-joints before reassembly. Re-check the yoke nut after the first few drives.
- Look for play at the yoke flange
- Check for leakage around the output seal
- Inspect the splines for wear before fitting
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18670.27 |
| UPC | 804314007119 |
| Transfer case | Dana 18 |
| Position | Rear |
| Warranty | Limited five year warranty |
Vehicle fitment
Omix-ADA lists 1959–1960 and 1966 Jeep CJ3 (Base); 1959–1960 and 1966–1971 Jeep CJ5 (Base); 1959–1960 and 1966–1971 Jeep CJ6 (Base); and Willys CJ-2 (1946–1949), CJ-3 (1949–1958), CJ-5 (1955–1958) and CJ-6 (1956–1958).
Not covered on this list: Jeep CJ5 years from 1961 to 1965, CJ7 models, and any Wrangler or Cherokee model. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The package is the rear yoke only. Check your existing seal and hardware before fitting the new yoke.









