Overview
The Rubicon Express RE1822 is a long slip yoke for the NP231 transfer case. It is an extended Cherokee slip yoke that adds 5/8 inch of length.
The added length also provides the operating angle needed to avoid driveshaft bind on lifted vehicles. It is intended for lifted pre-1996 Cherokees where a CV drive shaft kit is not used.
Key features
- Extended length of 5/8 inch
- Operating angle to avoid driveshaft bind on lifted vehicles
- Designed for the NP231 transfer case
- Extended Cherokee slip yoke
Driveshaft angles on lifted rigs
A slip yoke lets the driveshaft change length as the suspension moves, so it sits between the transfer case output and the front or rear driveshaft. When a lift raises the transfer case, the shaft angles change, and a yoke that adds length can help keep the shaft from binding at full travel.
Slip yokes need clean splines and a smooth slide to work properly. Inspect the yoke for scoring, grease fittings and the seal at the transfer case, and replace the seal if it leaks. Expect U-joints to wear faster if the angles stay steep, so check their play periodically after installation.
- Grease the slip yoke splines as directed
- Check seals for leaks after installation
- Watch for driveshaft vibration at highway speed
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1822 |
| UPC | 614901439014 |
| Transfer case | NP231 |
| Added length | 5/8 inch |
| Fitment | Direct fit |
Vehicle fitment
Confirm your exact Cherokee model and year before ordering, because fit depends on them.
Confirm your vehicle’s year, model and trim before ordering, and check the transfer case is an NP231.
Installation notes
Confirm the NP231 transfer case and driveshaft setup before installing the yoke.







