Overview
It is a tie rod end at steering knuckle with a left hand thread and an 11/16 inch thread diameter. It fits the 1984-1990 Jeep Cherokee (XJ) and the 1987-1990 Jeep Wrangler (YJ).
The inner position places this end on the knuckle side of the tie rod assembly. Omix-ADA presents it as a direct OE replacement built to original specifications.
Key features
- Left hand thread
- Thread diameter of 11/16 inch
- Inner position at the steering knuckle
- Direct fit listing for XJ and YJ
Knuckle end and toe adjustment
The end at the steering knuckle is the joint that turns the wheel as the tie rod moves. Its ball joint takes both steering load and suspension travel, so it wears steadily on vehicles that see rough roads. Signs of wear include a clunk over bumps, steering that feels loose on center and tires that wear on one edge.
When replacing it, check the adjuster sleeve and the jam nut for corrosion, since seized threads make toe adjustment harder. After installation, set toe and recheck it after a short drive, because a new joint can settle slightly in the first few miles.
- Check the adjuster sleeve for corrosion
- Inspect the other tie rod end
- Recheck toe after a short drive
- Look for seized jam nuts
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18043.05 |
| UPC | 804314050047 |
| Position | Inner |
| Thread direction | Left hand |
| Thread diameter | 11/16 inch |
| Fitment type | Direct fit |
| Warranty | Limited five year warranty |
Vehicle fitment
It fits the 1984-1990 Jeep Cherokee (XJ) and the 1987-1990 Jeep Wrangler (YJ).
The Wrangler (TJ) and Grand Cherokee (ZJ) are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 11/16 inch thread diameter and left hand direction must both match the removed end, so compare both before installing.
What’s included
One tie rod end at steering knuckle, part number 18043.05.









