Overview
The Omix-ADA 18043.25 is a front right outer tie rod end for the 1974 to 1988 Jeep J10 and J20 in the Base trim. It connects at the passenger side knuckle.
It is built as a direct OE replacement to the original specifications. It measures 50-1/2 inch long, and its UPC is 804314041328.
Key features
- Front right outer position
- Passenger side knuckle connection
- Length of 50-1/2 inch
- Direct OE replacement design to original specifications.
Steering geometry and wear
The outer tie rod end is the link between the steering arm and the front wheel. It takes the side load of every steering input, so it is one of the joints that wears first on a front axle. Play at this joint shows up as vague steering, wandering on the highway and uneven tire wear along the inner or outer edge of the tread.
Before replacing the end, lift the front wheel and check for movement at the joint while someone turns the wheel slightly. Inspect the rubber boot for cracks and grease loss, since a dry boot lets grit into the ball socket. After the new end is in, have toe set, because the end controls toe directly.
- Check for play with the wheel lifted
- Look for a torn or dry boot
- Reset toe after any tie rod change
- Inspect the opposite side too
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18043.25 |
| UPC | 804314041328 |
| Position | Front right outer |
| Connection | At passenger side knuckle |
| Length | 50-1/2 inch |
| Application | Direct OE replacement |
Vehicle fitment
It fits the 1974 to 1988 Jeep J10 and J20 in Base trim. Other Jeep models and years fall outside its fit.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Measure the old end against the 50-1/2 inch length before you fit this one.
What’s included
One tie rod end. Nuts, cotter pins and other hardware are not included, so check the package contents against your installation before starting.









