Overview
It is a front tie rod assembly that connects steering knuckle to steering knuckle. It fits the 1987-1990 Jeep Wrangler (YJ) in Base, Islander, Laredo, S, Sahara and Sport trims.
Omix-ADA presents it as a direct fit part for the front of the vehicle. Its knuckle-to-knuckle design links the steering at both front wheels.
Key features
- Connects steering knuckle to steering knuckle
- Front position
- Direct fit listing
- Fits the YJ generation, 1987-1990
Knuckle-to-knuckle steering geometry
A knuckle-to-knuckle tie rod ties both front wheels together, so it works as a single steering link across the axle. That makes it sensitive to any play in its joints, since small wear shows up as wheel scuffing and a steering wheel that drifts. On the YJ, the assembly also sits near the axle and gets dirt and road spray, so the boots and clamps need regular checks.
When inspecting, lift the front and check each joint for movement with the wheel turned, then look for cracked boots or loose clamps. Work on one side at a time when adjusting the length, and keep the setting close to the original so the alignment shop has less to correct. Replacing a worn joint with a new one usually calls for a full alignment afterward.
- Check both ends for movement
- Look for dirty or loose clamps
- Note the original length before adjusting
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18054.03 |
| UPC | 804314137465 |
| Position | Front |
| Connects | Steering knuckle to steering knuckle |
| Fitment type | Direct fit |
| Warranty | Limited five year warranty. |
Vehicle fitment
It fits the 1987-1990 Jeep Wrangler (YJ).
Wrangler models from other generations, such as the TJ and JK, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A knuckle-to-knuckle assembly sets the steering geometry at both wheels, so the alignment should be checked after installation.
What’s included
One tie rod assembly, part number 18054.03.









