Overview
The Trail Gear 186026-KIT is a rod end kit for steering linkage, with a 7/8 Inches – 14 left hand shank and a 5/8 Inches bore. Trail Gear marks it Universal Fit, so it is not built around one vehicle; match the thread and bore to your existing linkage before fitting.
The main body is 4340 Chromoly with a zinc coating, and the ball is AISI 52100 steel with a hard chrome-plated finish for a tough surface. A Teflon liner sits in the rod end and a jam nut comes with the kit.
Key features
- 4340 Chromoly body with zinc coating
- AISI 52100 ball with hard chrome plating
- Teflon liner
- Left hand thread direction
- Jam nut included
Rod end maintenance
A rod end is a pivot, so its service life depends on how well the ball stays lubricated and free of contamination. Check the boot or seal area for tears and look for grit near the ball. A Teflon liner reduces friction, but it still wears over time, so play in the joint is the sign to replace the rod end rather than adjust it.
Installation is worth doing with care. Set the jam nut after the rod end is at the right length, and tighten it so the nut does not back off. Recheck toe and steering alignment once the linkage is in place, since a changed rod end length moves the wheels.
- Check for play by hand at the ball
- Keep the ball free of grit and road dirt
- Recheck alignment after any length change
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 186026-KIT |
| UPC | 70000621724 |
| Shank | 7/8 Inches – 14 |
| Bore | 5/8 Inches |
| Thread direction | Left Hand |
| Body material | 4340 Chromoly, zinc coated |
| Ball material | AISI 52100, hard chrome-plated |
| Liner | Teflon |
| Fitment | Universal Fit |
Vehicle fitment
Universal Fit is the only fitment stated, and no vehicle, year or model is named. Verify the 7/8 Inches – 14 thread and 5/8 Inches bore against your existing linkage before fitting.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Left hand thread runs opposite to standard right hand rod ends, so confirm the thread direction on the linkage you are replacing before threading the kit on.
What’s included
The kit includes the rod end and the jam nut.









