Overview
The Moog K90259 is a bolt-on front right lower ball joint, part number MOGK90259, for the Toyota Tacoma. It fits the 1995 and 1997–1998 Tacoma in its Base and DLX versions.
Because it bolts to the knuckle, it installs without a press. It has a forged housing with more material in key areas, and it is designed to meet or exceed original equipment performance.
Key features
- Bolt-on design for the front right position
- Hardened ball stud for higher loads
- Forged housing with up to 52% more material in key areas
- Construction and design validated by Moog engineers
- Broad coverage for foreign and domestic applications
Bolt-on joint installation
A bolt-on lower joint is a simpler swap than a press-in unit, but it still carries the vehicle’s weight and steering load. Before removing the old joint, mark the knuckle and the fastener positions so the replacement aligns the same way. Penetrating oil on the fasteners helps, and new hardware is worth having on hand if the old bolts are seized or stretched.
Lower joints wear from the bottom up, so check the boot for tears and look for grease seepage. Play at the stud, a clunk over bumps, or uneven tread on the inside edge are the usual signs. Upper joints on the same truck can wear at a similar rate, so inspecting both during the same job saves a second trip.
After the new joint is in, have the front end aligned, since a change in ball joint height alters camber and caster. Check that the wheels turn freely and that the brake hoses and sensor wires are not stretched, then test drive at low speed before returning to normal use.
- Mark the knuckle before removing fasteners
- Use new hardware if old bolts are damaged
- Inspect the upper joint during the same job
Specifications
| Brand | Moog |
|---|---|
| Part number | MOGK90259 |
| Position | Front right lower |
| Joint type | Bolt-on |
| Lubeable | Yes |
| Housing | Forged, with up to 52% more material in key areas |
Vehicle fitment
It fits the 1995 and 1997–1998 Toyota Tacoma in its Base and DLX versions. Other Toyota models and non-Toyota vehicles are not covered, and Tacoma years from 1996 and from 1999 onward are excluded. Confirm fit for your vehicle’s year, model and trim before ordering.
Tacoma years from 1996 and from 1999 onward are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The fasteners that hold this joint to the knuckle are the working point for installation. Make sure the joint is on the right side before fitting it.
What’s included
One Moog front right lower ball joint, part MOGK90259.










