Overview
The Moog K8432T is a press-in front upper ball joint, part number MOGK8432T, for rear-wheel-drive Ford trucks. It fits the 1987–1997 Ford F-150, F-250 and F-350, plus the 1993–1995 F-150 Lightning and the 1997 F-250 HD.
It is an upper joint for two-wheel-drive trucks, not four-wheel-drive ones. It has a hardened ball stud, a forged housing and a greasable socket. The powdered metal gusher bearing carries grease to the stud, and the dust boot with an encapsulated Belleville washer is designed to control axial and radial movement. The pre-tapped grease fitting hole makes regular greasing practical after installation.
Key features
- Rear-wheel-drive trucks only
- Press-in installation into the knuckle
- Greasable socket and pre-tapped grease fitting hole
- Hardened ball stud for higher loads
- Dust boot with an encapsulated Belleville washer
- Forged housing with up to 52% more material in key areas
Off-road exposure and boots
Rear-wheel-drive trucks used off-pavement face the same dirt and water exposure as any other front suspension, and the upper joint’s boot is the first line of defense. A torn boot lets grit into the socket, which speeds wear on the stud and the bearing surfaces. Checking the boot after trail use and looking for grease that has been pushed out of the seal are simple habits that catch problems early.
When the joint is worn, the front end may feel loose on the highway or wander on uneven roads. Uneven tire wear across the tread is another clue. Replacing a worn joint restores the steering geometry, and an alignment after the work helps the new part wear evenly.
- Check the boot after every trail run
- Look for grease leaks around the seal
- Re-check fasteners after the first few drives
Specifications
| Brand | Moog |
|---|---|
| Part number | MOGK8432T |
| Position | Front upper |
| Drive type | Rear-wheel drive |
| Joint type | Press-in |
| Lubeable | Yes |
Vehicle fitment
It fits the 1987–1997 Ford F-150 (Base, Custom, Eddie Bauer, Lariat, Special, XL, XLT and XLT Lariat), the 1993–1995 F-150 Lightning, the 1987–1997 Ford F-250, the 1997 F-250 HD and the 1987–1997 Ford F-350.
Four-wheel-drive trucks and Ford models from outside these years are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This press-in joint needs a press or the correct installation tools to seat it in the knuckle. Confirm the truck is rear-wheel drive before removing the old joint, since this part fits only that drive type.
What’s included
One Moog front upper ball joint, part MOGK8432T.










