Overview
The Mag-Hytec Dana 80 High Capacity Cover (part DANA80) is a black A356-T6 aluminum rear differential cover for Dana 80 axles, with extra oil capacity.
Mag-Hytec designs its covers and transmission pans to add lubricant capacity and cooling for hard-working recreational and service vehicles. This cover has machined cooling fins, a magnetic drain plug and ARP 568 O-rings, and its hardware is stainless steel.
Dana 80 axles are large housings, so a higher-capacity cover adds meaningful volume to the oil. The machined fins carry heat to the outside air, and the magnetic drain plug works the same way on this cover as it does on other Mag-Hytec covers.
Key features
- Machined cooling fins on the aluminum body
- Magnetic drain plug for worn gear material
- ARP 568 O-rings
- Textured black powder coat
- Extra oil capacity
Heat and fill level
A rear differential cover does more than seal the housing. The cover is part of the lubricant system, and a larger cover holds more gear oil, which gives the gears a larger reserve and gives the oil more time to cool between hard runs. Heavy loads, steep grades and long highway pulls with a trailer all raise gear temperature, so cooler running oil helps the bearings and gears last longer.
When you install a higher-capacity cover, fill the housing to the correct level for your axle rather than to the old fill point, and use a gear oil grade suited to your axle and your driving.
Check the level after the first drive, then again after a few weeks of use. Oil that drops over time points to a seal or gasket problem, even though this cover uses O-rings. Look at the drain plug at each oil change. Fine metal particles are normal on a new build, but larger chips or heavy grit suggest the gears need a closer look.
- Check the fill level after the first few drives
- Inspect the magnetic drain plug at every oil change
- Look for seepage around the cover edge
Specifications
| Brand | Mag-Hytec |
|---|---|
| Part number | DANA80 |
| UPC | 70000402527 |
| Material | A356-T6 aluminum |
| Finish | Textured black powder coat |
| Axle location | Rear |
| Axle type | Dana 80 |
| Oil capacity | Extra |
| Drain plug | Magnetic |
| Seals | ARP 568 O-rings |
| Hardware | 303 stainless steel |
Vehicle fitment
It fits Dana 80 rear axles, so the axle type decides fit. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Mag-Hytec describes most installs as gasket-free and sealant-free, relying on the O-rings instead.
What’s included
A black aluminum cover with magnetic drain plug, O-rings and stainless steel hardware.
Not included: Gear oil.












