Overview
King Shocks Rear 2.0 Bump Stops, part number 20001-151, are hydraulic bump stops for the rear of a suspension. They add bottoming control when a vehicle uses all of its available travel. They are a universal fit.
The 2.0 is part of the product name and identifies this rear model. The piston design is intended to improve flow, and the shafts and seals use technology from King race shocks.
Key features
- Hydraulic rear bump stop for controlled bottoming near full travel
- Piston design King describes as offering superior flow characteristics
- Shafts and seals drawn from the same technology as King race shocks
- Nylon contact pad designed to run quietly and resist wear
Rear travel and bottoming
The rear suspension carries a large share of load on many vehicles, and it reaches bottoming more often when the rear is heavy, loaded or driven over sharp ruts. A rear bump stop engages after the springs and shock have used most of their travel, providing a controlled final stop. Its placement and height decide how early that controlled stop begins.
When replacing rear stops, check both sides together so the suspension behaves evenly. Look at the mounting bolt, the bracket it sits on and the contact pad for wear. Clean the pad and confirm it strikes the axle or arm squarely rather than at an angle, since off-angle contact causes uneven wear.
- Replace stops in matched pairs
- Check the rear mounting bolt
- Look for uneven contact wear
Specifications
| Brand | King Shocks |
|---|---|
| Part number | 20001-151 |
| UPC | 700007922151 |
| Type | Hydraulic bump stop |
| Position | Rear |
| Contact pad | Nylon |
| Mount | Single bolt |
| Fitment | Universal fit |
Vehicle fitment
Universal fit is shown, so no specific vehicle, year or model is attached. Confirm the rear mount and clearance suit your vehicle before ordering.
Universal rear stops can differ in length and mount location from one vehicle to another, so compare the stop with your original part. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The stop uses a single bolt mount. Check the bolt and mounting location against your rear suspension before installation.












