Overview
The King Shocks bump stop mounting sleeve, part number BS2541, is the mounting sleeve for King bump stops used at the end of suspension travel. King says its bump stops add bottoming control when a vehicle is using all of the suspension travel available. The sleeve gives a secure, sturdy mount without pinching the bump stop body.
King’s bump stop bodies come in 2.0 and 2.5 inch diameters with stroke lengths from 2 to 4 inches, chosen to fit different mounting locations. King bump stops add bottoming control when the suspension uses all of its available travel, and they are built to handle suspension arresting loads. This sleeve is a universal fit part, with no particular make, model, year or trim named.
Key features
- Sleeve holds the bump stop body without pinching it
- Single bolt mount design
- Part of King’s bump stop range, which comes in 2.0 and 2.5 inch diameter bodies
- Schrader cover mounts to the housing, not the valve, and seals out dust and moisture
- Piston design and micro polished, heat treated shafts.
- Long-wearing nylon contact pad that King describes as quiet in operation
Bump stop mounting basics
A bump stop only works at the end of suspension travel, so mounting geometry matters as much as the stop itself. A sleeve that holds the body square keeps the stop engaging at the same point every time, rather than rubbing or pivoting against a bracket. Uneven engagement can wear one side faster and can push the shock off its intended travel.
When choosing a sleeve, check the stop body diameter and stroke against the space you have, and make sure the mount clears the tire, brake line and axle at full compression. Bump stops are often replaced together with shock bushings and seals during service, since worn bushings can change the angle at which the stop meets the bracket. Dust and moisture are the main enemies of the stop body, so keep the mount clean and inspect the seal after off-road runs.
- Check the mount is square before tightening
- Clear the bump stop from brake lines at full compression
- Replace worn shock bushings at the same time
Specifications
| Brand | King Shocks |
|---|---|
| Part number | BS2541 |
| UPC | 700005450137 |
| Product type | Bump stop mounting sleeve |
| Bump stop body diameters | 2.0 and 2.5 inch (King bump stops) |
| Stroke lengths | 2 to 4 inches (King bump stops) |
| Contact pad | Long-wearing nylon |
| Fitment | Universal fit. |
Vehicle fitment
The sleeve is a universal fit, so it is not tied to a particular make, model, year or trim. Compatibility depends on the bump stop body and mounting location of your suspension.
No vehicles are named for BS2541, so measure the bump stop body diameter and mounting point before buying. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The sleeve is designed for a single bolt mount and avoids pinching the bump stop body. Confirm the bump stop body diameter before fitting, since 2.0 and 2.5 inch bodies are available. Support the vehicle securely before working near the suspension.
What’s included
The mounting sleeve is the item in this package. Check the package contents against your installation before starting.
Not included: The bump stop body itself is not part of this product and needs to be sourced separately.









