Overview
The G2 Axle and Gear 95-2015-001 is a replacement rear axle shaft for the GM 10 bolt 7.5 inch axle in the 1983–1989 Chevrolet S10 4WD. It has 26 splines and can be used on either the driver or passenger side.
G2 builds this shaft from alloy steel that it says is forged and heat treated to exceed OEM specifications. In the company’s description, the goal is a shaft that survives high-torque use and larger tires.
This single shaft serves both rear sides of the GM 10 bolt 7.5 inch axle in four-wheel-drive S10 trucks. Its 26 splines must match the differential gears, so check the gear count first. The shaft is built for higher torque use, which suits trail-focused S10 builds.
Key features
- Works on the driver or passenger side
- 26-spline shaft
- Fits the GM 10 bolt 7.5 inch rear axle
- Made for 1983–1989 S10 4WD
- Forged, heat treated alloy steel
- Wheel studs not included
Matching the 10 bolt axle
The GM 10 bolt 7.5 inch axle is used in four-wheel-drive S10 trucks, and its shafts depend on matching the 26-spline gears in the differential. Pull the cover and count the gear splines before ordering. Mismatched splines can slip or fail under load.
Because one shaft serves either side, the same part fits both positions. Compare the old shaft’s length, flange and spline ends with the new part. Look for twisted splines, a cracked flange or a bearing that feels loose, and replace any shaft that shows these signs.
Trail-focused S10 builds often add larger tires, which raises the load on the axle. Inspect the seal and bearing for wear, and replace the axle shaft and seal together if the old seal leaks. Re-check the wheel nuts after the first short drive.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2015-001 |
| UPC | 631410105988 |
| Product type | Replacement axle shaft |
| Axle type | GM 10 Bolt 7.5 inch |
| Axle location | Rear |
| Shaft position | Driver Or Passenger |
| Spline count | 26 |
| Wheel studs | Not included |
| Stated application | 1983-1989 S10 4WD |
Vehicle fitment
It fits the 1983–1989 Chevrolet S10 in 4WD form.
Later S10 models fall outside this range, so confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
- Check that your 10 bolt differential has 26-spline gears, since the shaft must match them.
- Wheel studs have to be supplied separately.
What’s included
One rear axle shaft that fits either side (95-2015-001).
Not included: wheel studs for the 95-2015-001.








