Overview
The G2 Axle and Gear 2-2029-456 is a 4.56 ratio rear ring and pinion for the Chrysler 8.25 inch rear axle. It is built for carriers rated 2.56 and up, so the carrier should meet or exceed that level.
G2 says these performance gears are made for oversized tires and high performance engines. The set uses computer heat treated 8620 steel with double shot peened and double lapped surfaces, manufactured to O.E. specifications.
Key features
- 4.56 ratio rear ring and pinion
- Chrysler 8.25 inch rear axle
- For use on 2.56 and up carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Carrier and gear mesh basics
The carrier holds the differential and must be strong enough for the torque and load that the ring gear carries. A rating of 2.56 and up is a minimum, so a carrier that is stronger than that gives the gears a sturdier mount under heavy loads. Carrier condition matters as much as the gear ratio, so inspect the case, bearings and bolts before the new set goes in.
Because the gears are a matched set, the pinion and ring must be set together. Pinion depth controls where the teeth meet, and backlash controls the small gap between them. A fresh set installed with the wrong backlash can whine or wear quickly, even when the parts are correct. Many shops replace the pinion seal and carrier bearings during the same job to avoid reopening the axle later.
- Inspect the carrier case for cracks
- Replace worn carrier bearings during the job
- Use fresh gear oil suited to your axle
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2029-456 |
| UPC | 631410093834 |
| Gear ratio | 4.56 |
| Axle location | Rear |
| Axle type | Chrysler 8.25 inch |
| Popular axle manufacturer | Chrysler |
| Carrier requirement | 2.56 and up |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It is made for the Chrysler 8.25 inch axle at a 4.56 ratio. Confirm the axle size and carrier before ordering.
Only the Chrysler 8.25 inch is named for this 4.56 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Set pinion depth, backlash and bearing preload on the 8.25 inch Chrysler gears with a driveline shop, then complete a break-in period.
What’s included
A matched ring and pinion for the Chrysler 8.25 inch rear axle.
















