Overview
The Fabtech FTS21104 is a 4-inch performance lift for the 2011 Chevrolet Silverado 2500 HD, 3500 HD, and GMC Sierra 2500 HD and 3500 HD. It uses heavy duty ductile iron steering knuckles and forged adjusting torsion bar keys to set the lift, which Fabtech says gives the proper amount of lift without CV bind.
The Uniball upper control arms are built from 4130 chromoly tubing with a 1.50-inch OD and provide 9 inches of front wheel travel. The 1-inch FK stainless PTFE Uniballs are not included in this kit, and shocks are not included either.
Key features
- 4-inch lift height
- Heavy duty ductile iron steering knuckles
- Forged adjusting torsion bar keys
- Designed to avoid CV bind at the set lift height
- Hardware kit included
Setting lift and CV angles
A heavy duty lift on a 2500 HD or 3500 HD truck changes the angle of the front axle shafts, which is why CV angle is a key consideration. Torsion bar keys set the height, so adjusting them evenly from side to side keeps the front end balanced. Recheck the adjustment after the first few trips, because the components can settle as they seat.
Upper control arms with Uniballs add a further consideration, since joints wear faster under heavy loads. Inspect the Uniballs for play, binding and contamination, and replace any joint that feels loose when moved by hand. Steering knuckles and the hardware kit should be checked for tight, even torque. Alignment should be set once the truck is at its final height.
- Adjust torsion bar keys evenly from side to side
- Recheck torsion key settings after the first few trips
- Inspect Uniballs for play at each service
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS21104 |
| UPC | 674866034174 |
| Lift height | 4 inches (range 3 to 4.99 inches) |
| Suspension type | Knuckle |
| Front components | Steering knuckles and torsion bar keys |
| Upper control arm tubing | 0.120 wall 4130 chromoly, 1.50-inch OD |
| Front wheel travel | 9 inches with the arms |
| Uniballs | 1-inch FK stainless PTFE, not included |
| Rear lift method | Lift blocks and U-bolts |
| Shocks | Not included |
Vehicle fitment
It fits the 2011 Chevrolet Silverado 2500 HD, the 2011 Chevrolet Silverado 3500 HD, the 2011 GMC Sierra 2500 HD and the 2011 GMC Sierra 3500 HD.
The list covers the 2011 model year only, and the 1500 trucks are not included. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit includes steering knuckles and torsion bar keys, and the lift is set by adjusting the torsion bar keys. The 1-inch FK stainless PTFE Uniballs are not included, so they must be obtained separately.
What’s included
Heavy duty ductile iron steering knuckles, forged adjusting torsion bar keys, the rear block and U-bolt kit and a hardware kit.
Not included: The 1-inch FK stainless PTFE Uniballs and shocks.









