Overview
It is sized for the 8.5 inch GM 10 bolt housing, and it is manufactured by Eaton under the Detroit Locker name.
Under power, the locker drives both wheels on the axle at the same time, so a tire that still has grip keeps working when the other spins. It delivers 100% of the torque to both drive wheels. The axle types covered are GM 10 bolt 8.6 inch and GM 10 bolt 8.5 inch.
Key features
- Delivers torque to both wheels on the axle
- Automatic speed differentiation through turns
- 28 spline axle fit
- Axle position: front or rear
- Eaton cites mud, snow, rocks and track use
Carrier work and setup
A locker for a GM 10 bolt sits inside the carrier, so the work is more than swapping a part. The pinion depth, gear mesh and bearing preload all have to be set again once the locker is in. Gear shops usually check each of these with the carrier on a bench before it goes back into the axle.
The housing size and the carrier design both decide what fits. Two 10 bolt housings can look alike while differing in pinion location or bearing bore. Taking the housing measurements before buying the locker avoids a wasted trip to the shop.
- Verify pinion depth and gear mesh before reassembly
- Inspect axle bearings and seals while the axle is apart
- Set bearing preload to the carrier’s specification
- Break in new gears gradually after installation
Specifications
| Brand | Detroit Locker |
|---|---|
| Manufacturer | Eaton |
| Part number | 187C149A |
| UPC | 70000010122 |
| Axle manufacturer | GM |
| Axle location | Front or rear |
| Axle type | GM 10 bolt 8.6 inches and GM 10 bolt 8.5 inches |
| Axle spline count | 28 splines |
| Differential type | Automatic locker |
Vehicle fitment
Fitment here is by axle, with no vehicle years given. The match is GM 10 bolt housings in the 8.5 and 8.6 inch sizes with 28 splines. Verify the housing size and spline count before installation, since a 10 bolt of another size is a different axle.
Fitment is by axle rather than by vehicle year. It covers GM 10 bolt housings in the 8.5 and 8.6 inch sizes with 28 splines. Measure the housing and count the splines before installation, since a 10 bolt of another size is a different axle. Check the year, model and trim against your vehicle before buying.
Installation notes
Front or rear use means the work happens inside the axle carrier, and the locker has to match the housing’s pinion and carrier. Have a gear shop check gear mesh and bearing preload after fitting, and break in the new gears gradually. Keep the axle supported while the carrier is out.
What’s included
The item is the locker unit, part number 187C149A.






