Overview
The Detroit Locker 912A556 is a TrueTrac limited slip differential for GM 10 bolt rear axles in the 8.5 inch axle type with 28 splines. Eaton’s part number for this unit is EAT912A556. It uses a gear driven, clutchless layout, so limited slip action does not depend on friction clutches.
Torque goes to the wheel that still has grip when the other wheel spins, which can help a vehicle leave soft ground or climb out of a rut. With no clutches to replace, the unit is designed for long service life.
Key features
- Gear driven, clutchless TrueTrac limited slip design
- Moves power automatically from a slipping wheel to the non slipping wheel
- No clutch packs to replace
- GM 10 bolt 8.5 inch axle type
- 28 spline axle connection
- Limited slip assembly for the rear axle
Gear setup after installation
A GM 10 bolt 8.5 inch rear is often installed with a new carrier, so the ring and pinion should be set before the unit is trusted off road. Tooth contact and backlash are checked with the gears loaded, and bearing preload should be set to the axle’s own requirement. A shop with the right tools can confirm both in one visit.
Because the TrueTrac is gear driven, the gears carry the limited slip action. Keep the gear oil clean and at the correct level, and watch for leaks at the cover and axle seals. Noise that changes with speed or a clunk when turning is worth investigating early.
- Check tooth contact pattern before final assembly
- Set bearing preload and backlash
- Inspect axle seals during install
- Change gear oil at the interval the axle requires
Specifications
| Brand | Detroit Locker |
|---|---|
| Part number | 912A556 |
| UPC | 70000335694 |
| Axle manufacturer | GM |
| Axle location | Rear |
| Axle type | GM 10 bolt 8.5 inches |
| Axle spline | 28 splines |
| Differential type | Limited slip assembly (TrueTrac) |
Vehicle fitment
The 912A556 fits a rear GM 10 bolt axle in the 8.5 inch axle type with 28 splines. Fit depends on the axle rather than vehicle model, so match those measurements before buying.
Confirm fit for your vehicle’s year, model and trim before ordering. A different axle type or spline count does not match this unit.
Installation notes
Check the 8.5 inch axle type and 28 spline count against your housing and axle shafts first, because a mismatch will not seat. Replacing a rear differential assembly calls for gear setup and tooth contact checks, so have a qualified technician install and set up the unit.
What’s included
The unit is the differential assembly, so compare the package against your installation before starting.
Not included: Confirm whether axle shafts, bearings or installation hardware are included before starting the job.






