Overview
The Crown Automotive JA000866 is a spindle nut for the front axle, fitting Dana 44 and standard Dana 30 axle types. It is universal fit and covers older CJ, Willys and Commando models.
A spindle nut holds the wheel bearing and hub assembly on the spindle. This one fits Willys MB, CJ-2, CJ-3, CJ-5 and CJ-6 models from 1941 through 1958, and CJ3, CJ5, CJ6 and CJ7 models from 1959 through 1986. It also fits the Commando from 1966 through 1973 and the Scrambler from 1981 through 1985.
Key features
- Front axle spindle nut
- Dana 44 and standard Dana 30 axle types named
- Universal fit listed
- Part number JA000866
Torque and fitting care
A spindle nut holds the wheel bearing and hub on the spindle, so its job is to set bearing preload correctly. A nut that is too loose lets the hub move and wear the bearing, while one that is overtightened can heat the bearing and shorten its life.
Set preload with the method that suits your axle, and recheck after the first drives. Inspect the threads on the spindle for damage before you install a new nut, since cross-threaded threads can make a correct nut feel wrong.
Wheel bearings and the hub seal often get serviced at the same time. Replacing the nut alone is rarely the fix for a bearing that has already run loose, so check the bearing races, the hub seal and the spindle for wear while the hub is off.
- Hub play when the wheel is rocked
- Warm hub after a short drive
- Burrs or rust on spindle threads
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | JA000866 |
| UPC | 848399073126 |
| Position | Front |
| Axle type | Dana 44 and Dana 30 standard |
| Fitment | Universal fit |
Vehicle fitment
It fits older CJ and Willys models, including the Commando and the Scrambler.
Wrangler and Grand Cherokee models are not in the list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One spindle nut.








