Overview
The Dana Spicer Dana 60 spindle nut with pin, part number 660568, is an inner spindle nut for Dana 60 front axles. It is a single nut for one side of the axle rather than a complete set, so match it to the side you are replacing.
It is a Universal Fit part for front Dana 50, Dana 60 and Dana 61 axles, with no model years or vehicles linked to it.
Key features
- Inner nut with pin
- Serves one side only
- Front axle location
- Axle types Dana 50, Dana 60 and Dana 61 shown
Setting spindle nut preload
The spindle nut sets the bearing preload that holds the hub in place, so it has a direct effect on wheel play and bearing life. An inner nut with pin is usually installed first, and the pin keeps the nut from backing off once the outer nut is set. Clean the threads and check that the nut seats flat against the bearing before tightening.
Replace the nut when the threads are damaged or the pin is bent, since a worn nut can allow the hub to shift. Set preload following your service procedure, using a torque wrench and the correct sequence for the axle. After a short drive, check for heat at the hub and any play at the wheel, and recheck the setting if either is found.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 660568 |
| UPC | 23913147501 |
| Nut type | Inner nut with pin |
| Axle location | Front |
| Axle types | Dana 50, Dana 60, Dana 61 |
| Service | One side only |
Vehicle fitment
Our fitment list has no vehicles for this nut. Dana Spicer shows a Universal Fit label across Dana 50, Dana 60 and Dana 61 front axles, with no model years given.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
One inner spindle nut with pin is included. The outer nut, washers and other hub parts are separate items.









