Select your vehicle

Dana Spicer Dana 60 Crush Sleeve – 45658

Dana Spicer

Shop on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Slickrock 4X4 is a participant in the Amazon Associates Program. As an Amazon Associate we earn from qualifying purchases.

  • Dana Spicer 45658 crush sleeve for Dana 60 axles
  • Maintains proper pinion bearing preload
  • Made for late model factory style ring and pinions

Description

Overview

The Dana Spicer 45658 is a crush sleeve for Dana 60 axles, made for late model factory style ring and pinion setups. It is a direct replacement for dealer crush sleeves, which Dana Spicer describes as hard to find and expensive. Its job is to maintain pinion bearing preload.

Key features

  • Direct replacement for dealer crush sleeves
  • Maintains proper pinion bearing preload
  • Made for late model factory style ring and pinions
  • Dana 60 axle type
  • Suited to front and rear axle locations.

Checking ring and pinion style

A crush sleeve sets pinion bearing preload by compressing as the pinion nut tightens. Once it has been crushed, it cannot be reused, which is why it is normally replaced every time the pinion is set up again. A replacement sleeve gives the same spacing as the original when the ring and pinion style matches. Keep bearing faces clean and lubricated during assembly.

Work carefully when tightening. Tighten the pinion nut in small steps, measuring rotational torque as you go, so the sleeve does not over-compress. Once preload is in range, check the ring gear backlash and tooth pattern, because a changed pinion position can throw them off.

  • Pinion nut, replaced with the sleeve
  • Pinion bearings in good condition
  • Ring gear backlash and pattern check

Specifications

Brand Dana Spicer
Part number 45658
UPC 23913142513
Axle type Dana 60
Axle location Front and rear
Application Late model factory style ring and pinions
Fitment listed Universal fit

Vehicle fitment

No specific vehicle is tied to it. Dana 60 is the axle type, with universal fit, so the ring and pinion style and axle housing decide fit.

Dana 60 is an axle model, not a vehicle. Confirm your vehicle’s year, model and trim before ordering.

Installation notes

The sleeve compresses as the pinion nut is tightened, so it is normally replaced whenever the pinion is set up again. Have the pinion preload checked by a qualified shop after installation.

What’s included

Only the crush sleeve is described.

Not included: Pinion bearings and nut are sourced separately.

SKU: D/S45658 Category:

Specification

Shipping weight 0.10 lbs
Package dimensions 2.80 × 2.80 × 1.30 in
brands

Questions & Answers

Does the Dana Spicer 45658 fit a Dana 60 axle?

Yes, it is made for Dana 60 axles and is universal fit. No vehicle is tied to it, so confirm the axle housing and ring and pinion style before ordering.

Is 45658 meant for older Dana 60 gear sets?

No. It is made for late model factory style ring and pinions, so check your ring and pinion design before ordering this crush sleeve.

What does a crush sleeve do in a Dana 60?

It sets pinion bearing preload, which keeps the pinion bearings properly tensioned. The Dana Spicer 45658 is a direct replacement for dealer crush sleeves on Dana 60 axles.

Can a crush sleeve be reused after the pinion is torqued?

No. The sleeve compresses to set preload, so once it has been crushed its length has changed and it will not hold the same setting. Install a new sleeve each time the pinion is set up.

Find it on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Shop on Amazon