Select your vehicle

Dana Spicer Dana 35 Crush Sleeve – 42102

Dana Spicer

$11.99In stock
Buy on Amazon

See similar parts on Amazon

Price and availability as of Nov 18, 2026 2:20 PM MST, from Amazon.com, and subject to change. The Amazon listing has the current details.

Check out with your Amazon account. Amazon handles delivery and returns.

Slickrock 4X4 is a participant in the Amazon Associates Program. As an Amazon Associate we earn from qualifying purchases.

  • Dana Spicer 42102 crush sleeve for Dana 35 axles
  • Direct replacement for dealer crush sleeves on late model axles
  • Short description names rear Dana 35 axles

Description

Overview

The Dana Spicer 42102 is a crush sleeve for Dana 35 axles, made to replace the factory crush sleeve that sets pinion bearing preload. It is a direct replacement for dealer crush sleeves on late model axles that use factory crush sleeves, which can be hard to source and costly to buy.

Key features

  • Direct replacement for factory style crush sleeves
  • Designed for Dana 35 axles
  • Made for late model axles equipped with factory crush sleeves

Crush sleeve versus solid spacer

Pinion bearing preload keeps the pinion gear steady under load, and it is set by tightening the pinion nut against the sleeve. A crush sleeve collapses to hold that setting, which means it is set once and replaced when the pinion is taken apart again. A solid spacer works differently and holds preload without crushing, so it is not a simple swap in every setup.

When replacing a crush sleeve, check the pinion bearings, pinion seal and carrier shims together. Old bearings that were already running loose can lose preload quickly and cause early wear. Use a torque wrench on the pinion nut, measure rotating torque, and recheck it after the first drives. A qualified shop can handle this with the right tools.

Specifications

Brand Dana Spicer
Part number 42102
UPC 23913140939
Axle type Dana 35
Axle location Front or rear; confirm your housing before ordering
Fitment listed Universal fit

Vehicle fitment

The sleeve is made for Dana 35 axles. Check your axle housing before ordering.

Dana 35 is an axle model, not a vehicle. Confirm your vehicle’s year, model and trim before ordering.

Installation notes

A crush sleeve collapses as the pinion nut is tightened to set bearing preload, so it is normally installed once during a pinion setup and replaced rather than reused. Have the pinion preload checked by a qualified shop.

What’s included

Only the crush sleeve is included.

Not included: Bearings and the pinion nut are not included with this sleeve.

SKU: D/S42102 Category:

Specification

Shipping weight 1.00 lbs
Package dimensions 4.00 × 4.00 × 1.00 in
brands

Questions & Answers

Does the Dana Spicer 42102 fit Dana 35 rear axles?

Yes, it is made for Dana 35 axles. Confirm the axle location and pinion setup on your housing before ordering.

Is 42102 a crush sleeve or a bearing spacer?

It is a crush sleeve. A crush sleeve collapses to set pinion bearing preload, while a solid spacer holds that preload without crushing, so the two are not interchangeable in every setup.

What is the part number of the Dana Spicer Dana 35 crush sleeve?

The part number is 42102. Dana Spicer is the brand, and the sleeve is for Dana 35 axles. Check your axle housing before ordering.

Should a crush sleeve be reused?

No. A crush sleeve should be replaced once it has been compressed. Its job is to set preload as it collapses, so a used sleeve cannot reliably hold the same setting. Install a new sleeve each time the pinion is set.

Ready to order?

Order this part on Amazon and check out with your Amazon account. Amazon handles delivery and returns.

Buy on Amazon