Overview
The Dana Spicer Dana 44 JK Crush Sleeve, part 50614, is a crush sleeve for late model factory style ring and pinion sets on Dana 44 axles. Its job is to hold proper pinion bearing preload.
It replaces the factory crush sleeve on late model axles that use one. It is made for 2007 and later JK axles.
Key features
- Maintains proper pinion bearing preload
- Direct replacement for factory crush sleeves
- For late model factory style ring and pinion sets
Pinion preload basics
Pinion preload is the drag applied to the pinion bearings when the carrier is assembled. It keeps the pinion from moving under load, which protects the gear mesh and bearings. A crush sleeve sets this preload by compressing as the pinion nut is tightened, so the nut has to be brought up gradually rather than all at once.
Preload is checked by turning the pinion with a torque wrench and reading the drag against the value required for the carrier. Too little preload lets the pinion shift and the gears wear quickly, while too much makes the bearings run hot and can crush the spacer beyond use. Set preload during the carrier rebuild, and recheck it after the first few drives.
- Check drag with a torque wrench
- Tighten the pinion nut in small steps
- Do not reuse a compressed sleeve
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 50614 |
| UPC | 23913145491 |
| Axle type | Dana 44 |
| Location | Front or rear |
| Use | Late model factory style ring and pinion |
Vehicle fitment
It is made for 2007 and later JK axles. Check the axle, the ring and pinion style and the existing crush sleeve on your differential before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A crush sleeve is compressed when the pinion nut is tightened, so use a new sleeve rather than reusing the old one, and set pinion preload when the carrier is rebuilt.
What’s included
One crush sleeve.









