Overview
The Dana Spicer Dana 30 open differential internal kit, part number 706010X, replaces the internal components of a Dana 30 open differential. It has two spider gears, two 27 spline side gears, shims, a cross shaft and a cross shaft retainer pin.
It is a direct fit for Dana 30 standard, reverse, JK and TJ axle types with 27 spline shafts. It is for open differentials only and is not a limited slip kit.
Key features
- Replaces all of the internal components of an open differential
- 27 spline side gears for 27 spline axles
- Shims included with the spider and side gears
- Open differentials only
Checking a differential rebuild
An internal kit changes the way the differential shares torque between the wheels, so the spider and side gear fit must be right. Lay out each part as it comes out of the case, and inspect the spider gears and side gears for chipped teeth, pitting and heat discoloration. Replace any part that shows damage rather than mixing old and new parts in one assembly.
Shim thickness sets the clearance between the gears, and the right thickness is found by measuring during assembly. Too little clearance can bind the gears, and too much allows play and noise. Lubricate all contact surfaces with gear oil as you assemble, and check backlash and tooth contact before returning the axle to service.
- Replace spider and side gears as a set when worn
- Measure and set shim thickness during assembly
- Check the differential case for cracks before reuse
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 706010X |
| UPC | 23913133009 |
| Kit type | Open differential internal kit |
| Axle spline | 27 splines |
| Differential case | Open only |
| Axle types listed | Dana 30 standard, Dana 30 reverse, Dana 30 JK, Dana 30 TJ |
Vehicle fitment
Fitment is listed by axle type, not by vehicle. The Dana 30 standard, reverse, JK and TJ axles are the ones named, and the kit is for open differentials with 27 spline axles.
Installation notes
Because the shims are set during assembly, gear backlash and pattern should be checked before the axle goes back into service. A professional setup is the safer route for a differential rebuild.
What’s included
Two spider gears with shims, two 27 spline side gears with shims, one cross shaft and one cross shaft retainer pin.
Not included: the differential case, ring gear and axle shafts.









