Overview
The CURT 55571 is a wiring T-connector with a powered converter and 3-wire system for the Nissan Murano. It is designed for 2003–2005 and 2009–2013 model years in CrossCabriolet, LE, S, SE, SL and SV trims.
It plugs direct into the factory harness and includes a 4-pin connector, a dust cap and a ground wire with self-tapping screw. The listed install time is 25 minutes.
Key features
- Powered converter with 3-wire system
- Plugs direct into the factory harness
- 4-pin connector
- Dust cap for the connector
- Ground wire with self-tapping screw
Murano wiring and trailer use
The Murano’s factory harness carries the lighting and signal circuits that a trailer connection depends on. A T-connector with a powered converter lets those circuits feed a trailer without cutting into the vehicle’s wiring. Because the connection point is shared with other systems, it helps to know which functions the trailer needs before installing.
Trailer lighting problems often come from the ground or the connector pins rather than the converter itself. Inspect the plug for moisture, bent contacts or heat marks, and keep the connection covered when the trailer is unhitched. Testing each function after installation makes it easier to spot a fault early.
- Test running lights, brakes and turn signals after installing
- Keep the dust cap on when the trailer is unhitched
- Check the harness plug for heat discoloration
Specifications
| Brand | CURT Manufacturing |
|---|---|
| Part number | CRT55571 |
| Wiring system | 3-wire with powered converter |
| Connector | 4-pin |
| Included hardware | Dust cap, ground wire and self-tapping screw |
| Install time | 25 min. |
Vehicle fitment
It fits the 2003–2005 and 2009–2013 Nissan Murano in CrossCabriolet, LE, S, SE, SL and SV trims.
Murano model years from 2006 through 2008 are not on this list, and neither are years after 2013. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Allow the listed 25 minutes for the job. Fasten the ground wire with its self-tapping screw after the connector is seated in the factory harness.
What’s included
Converter-equipped T-connector, 4-pin connector, dust cap, ground wire and self-tapping screw.
Not included: trailer wiring.









