Overview
The CURT 55381 is a standard 2-wire wiring T-connector for vehicles with a factory 7-way trailer connector. It fits 2000 to 2015 Dodge Dakota, Durango and Ram 1500, 2500 and 3500 trucks, Jeep Grand Cherokee WJ and WK, the Chrysler Aspen and the 2011–2013 Chevrolet Silverado 3500 HD.
It plugs direct into the factory harness and includes a 4-pin connector, a dust cap and a ground wire with self-tapping screw.
Key features
- Standard 2-wire system
- Designed for vehicles with a factory 7-way connector
- 4-pin connector included
- Dust cap included
- Ground wire with self-tapping screw
Wiring considerations for towing
A T-connector splits power and ground circuits from the factory harness so a trailer lighting connection can be made without cutting into the vehicle’s wiring. The ground path matters most: a weak or corroded ground is a common reason trailer lights flicker or dim, so clean the contact point to bare metal before tightening the self-tapping screw.
Check the connector seating and the dust cap after every install and periodically during the season. Moisture that gets into the harness can cause intermittent faults that are hard to trace later, so keep the cap fitted whenever no trailer is connected.
- Test every light circuit after installation
- Route trailer wire away from exhaust and moving parts
- Use dielectric grease on terminals in wet climates
Specifications
| Brand | CURT Manufacturing |
|---|---|
| Part number | CRT55381 |
| Wiring system | Standard 2-wire |
| Connector | 4-pin |
| Factory connector | 7-way |
| Included hardware | Dust cap, ground wire and self-tapping screw |
| Install time | 5 min. |
Vehicle fitment
It covers 2000–2015 Dodge Dakota, Durango, Ram 1500, Ram 2500 and Ram 3500, Jeep Grand Cherokee WJ (2000–2004) and WK (2005–2009), Chrysler Aspen (2007–2008) and Chevrolet Silverado 3500 HD (2011–2013), in the trims named for each model.
Jeep Grand Cherokee years outside 2000–2009 and Ram trucks outside the years listed are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Connect the T-connector to the factory harness, then fasten the ground wire with the included self-tapping screw. Disconnect the battery before routing any trailer wiring.
What’s included
T-connector with 4-pin connector, dust cap, ground wire and self-tapping screw.
Not included: a trailer or trailer wiring.









