Overview
The Curt Manufacturing 56110 is an OEM replacement wiring T-connector with a 4-flat connection for the 2011–2013 and 2015–2018 Ford F-150, part number CRT56110. It plugs directly into the factory harness and includes a 4-pin connector.
The kit also contains a dust cap and a ground wire with a self-tapping screw. The install time is 10 min for this T-connector.
Key features
- OEM replacement design
- Plugs directly into the factory harness
- 4-flat connection with a 4-pin connector
- Dust cap included
- Ground wire with self-tapping screw included
Ground connection tips
A tail light or trailer T-connector is only as reliable as its ground. Most intermittent lighting faults trace back to a ground that is painted, rusted or loose, so the metal under the self-tapping screw should be cleaned to bare metal before the screw goes in. A small amount of dielectric grease on the screw threads helps slow corrosion later, and a star washer keeps the screw from backing out under vibration.
After the first few drives, check the screw and the connector latch. Wiggle the harness gently with the lights on to see whether the signal changes. If a lamp drops out, the cause is often the ground or the plug seating rather than the bulb. Keep spare self-tapping screws on hand in case the threads strip during installation.
- Clean paint and rust from the mounting point
- Use a star washer under the screw head
- Recheck the screw after the first few drives
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | CRT56110 |
| Connection | 4-flat |
| Connector | 4-pin |
| Install time | 10 min |
| Included | Dust cap, ground wire with self-tapping screw |
Vehicle fitment
It fits the 2011–2013 and 2015–2018 Ford F-150 in FX2, FX4, Harley-Davidson Edition, King Ranch, Lariat, Lariat Limited, Limited, Platinum, Raptor, SSV, STX, XL and XLT trims.
For a Ford F-250 Super Duty or Ford Expedition, verify year, model and trim against your truck before buying.
Installation notes
Attach the ground wire’s self-tapping screw to bare metal so the ground connection stays solid. The install time is 10 min.
What’s included
The kit includes a 4-pin connector, a dust cap, and a ground wire fitted with a self-tapping screw.









