Overview
The Crown Automotive A490K is a U-bolt kit for axles with a U-bolt style yoke, sold as a pair. Crown’s application notes cover Jeep CJ, YJ, TJ, XJ and ZJ models from 1941 through 2003, including Dana 25, 27, 30 and 44 differentials, an AMC-20 rear axle and a Dana 20 transfer case front or rear output.
U-bolts clamp an axle to its leaf springs, so this kit suits anyone replacing or matching the U-bolts on one of the listed axles. Each application is tied to a specific model, year and axle type.
Key features
- Sold as a pair for U-bolt style yokes
- Application notes cover Dana 20, 25, 27, 30 and 44 axles plus AMC-20 rear axles
- Separate entries for CJ, YJ, TJ, XJ and ZJ models by year and axle type
- Direct Fit for the specific model, year and axle type in each application entry.
Matching U-bolt style yokes
U-bolt style yokes differ from other axle clamps, so the first step is confirming the yoke style before any purchase. Dana 25, 27, 30 and 44 axles, along with AMC-20 rear axles, can use different U-bolt sizes and spacing. Measure the existing U-bolts and compare the axle housing and spring seat to make sure the new pair lines up.
Pairs are commonly replaced together, since uneven clamp force can distort the axle seat and cause fasteners to loosen. Check the spring pad and axle seat for wear while the U-bolts are off, and replace any damaged parts. Clean threads thoroughly before reassembly so the nuts turn freely and seat evenly.
Yoke style also affects which axle application applies, so verify the axle and transfer case output before purchase. If the vehicle has been regeared or swapped, confirm the axle model from the housing casting rather than from memory.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | A490K |
| UPC | 848399078480 |
| Quantity | Pair |
| Yoke type | U-bolt style yoke |
| Fitment type | Direct Fit |
Vehicle fitment
Fitment is listed by application rather than as a vehicle table. Entries include 1941-1995 CJ, XJ and YJ with Dana 30 front U-bolt kits, 1997-2001 TJ with Dana 30 front kits without disconnect, 1993-1998 ZJ, and 1976-1986 CJ with AMC-20 rear kits. Confirm your vehicle’s year, model and trim before ordering.
Models and years outside these application entries, such as Wrangler JK and later, are not covered by this kit’s notes.
Installation notes
Check the U-bolt style and axle type against your yoke before fitting, since the application notes differ by axle. Support the axle safely while the old U-bolts are removed.
What’s included
The kit is sold as a pair for U-bolt style yokes. Confirm which nuts, plates and other hardware are included before installing.








