Overview
The Tuff Country 17757 is a zinc plated axle U-bolt for the rear of 1973–1987 Chevrolet and GMC pickups. The list covers the Chevrolet C10, K10, R10 and V10 and the GMC C15, K15, R1500, V1500, C1500 and K1500 models in the trims shown.
It is a rear axle part and a direct fit for the trucks covered. Confirm the thread size and axle fit for your truck before ordering.
Key features
- Zinc plated U-bolt
- Rear axle position
- Direct fit for the listed trucks
- Tuff Country part number T/C17757
Choosing and fitting a U-bolt
A U-bolt holds the axle to the leaf spring, so its job is to clamp steadily rather than to carry the load itself. Because the clamp depends on a tight fit around the spring and axle, the U-bolt should sit square with the axle tube and never be forced into place. A bent or stretched U-bolt cannot hold its clamp, so it should be replaced rather than straightened.
Zinc plating gives a U-bolt basic protection against rust, but the coating wears where the bolt rubs against the nut and the spring pad. Inspect the threads and the coating during routine service, and replace the nuts together with the U-bolts so the clamp is even on both sides of the axle.
- Check that the U-bolt sits square against the axle tube
- Look for bent legs or stretched threads
- Replace worn nuts with the U-bolts
- Re-tighten after the first few drives
Specifications
| Brand | Tuff Country |
|---|---|
| Part number | T/C17757 |
| Type | Axle U-bolt |
| Finish | Zinc plated |
| Position | Rear |
| Fitment | Direct fit |
Vehicle fitment
It fits the 1973–1986 Chevrolet C10 and K10, the 1987 Chevrolet R10 and V10, the 1973–1974 GMC C15 and K15, the 1979–1986 GMC C1500 and K1500, the 1975–1978 GMC K15, and the 1987 GMC R1500 and V1500, in the trims covered.
Trucks from outside these years and the 1988 and later models are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the axle mounting after the new U-bolt is fitted.









