Overview
The 83502883 is a Dana 35 rear driver side axle shaft, 30.35 inches long with 27 splines. It fits non-ABS 1984–1989 Jeep Cherokee XJ, 1986–1989 Comanche and 1987–1989 Wrangler YJ models. It sits on the driver side of the Dana 35 rear axle, in the rear left position. At 30.35 inches it is longer than the passenger side shaft for the same axle.
The driver side shaft is the longer of the pair at 30.35 inches. It has 27 splines, is a direct fit, and every fitted vehicle ends at the 1989 model year. Anyone with a later XJ, Comanche or YJ, or a vehicle with ABS, should confirm fit before choosing this shaft. Replacing both rear shafts means fitting this driver side shaft together with its passenger side partner, 83502882.
Key features
- Driver side rear axle shaft
- 30.35 inches long
- Dana 35 rear axle, 27 splines
- For non-ABS models only
- Position given as rear left
- Classed by Crown Automotive as a direct fit
Driver side shaft service
The driver side rear shaft carries the same load as its partner, so wear on one side is a good reason to check the other. Look at the spline ends, the shaft surface and the bearing area for scoring, heat marks or play. A shaft that has twisted under load should be replaced rather than straightened.
Removing the shaft usually calls for a puller designed for the axle flange, and the bearing and retainer should be kept in order so they can be inspected. Support the vehicle securely and drain the axle before starting. Clean the spline area thoroughly to help the shaft seat properly on reassembly.
- Check the spline ends for wear or twisting
- Inspect the shaft surface and bearing area for heat marks
- Keep the bearing and retainer parts in order
- Drain the axle before removing the shaft
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 83502883 |
| UPC | 848399075236 |
| Axle manufacturer | Dana |
| Shaft location | Driver Side |
| Axle position | Rear |
| Axle type | Dana 35 |
| Position | Rear Left |
| Spline count | 27 Splines |
| Length | 30.35 inches |
| ABS | Non-ABS models |
Vehicle fitment
It fits three older Jeep models.
- 1984–1989 Jeep Cherokee (XJ) (Base, Chief, Laredo, Limited, Pioneer, Sport)
- 1986–1989 Jeep Comanche (Base, Chief, Custom, Eliminator, Laredo, Pioneer, X, XLS)
- 1987–1989 Jeep Wrangler (YJ) (Base, Islander, Laredo, S, Sahara, Sport)
Coverage ends at 1989 for the XJ, Comanche and YJ, and applies to non-ABS vehicles only. Anything newer, including the TJ, is not in the list. Confirm your vehicle’s year, model and trim before ordering.







