Overview
The Crown Automotive 5012456AB is a Dana 30 front CV axle shaft assembly for the passenger side of the 1999–2004 Jeep Grand Cherokee WJ. It is the front right shaft assembly in the CV type without Vari-Lok. A CV (constant-velocity) shaft has joints that keep it turning smoothly while the front wheels steer and the suspension moves, which is why front axle shafts on these Jeeps are built as assemblies rather than plain bars.
The shaft is for the Dana 30 TJ axle type, the front axle position and the passenger side, with 27 splines. It is a full assembly, so the joints come with it. It links the front differential of a WJ Grand Cherokee to the passenger side front wheel, and it is the part to consider when a CV joint boot has torn or the joint has started to click.
Key features
- Passenger side front axle shaft assembly
- CV type without Vari-Lok
- Dana 30 front axle, 27 splines
- Position given as front right
- Classed by Crown Automotive as a direct fit
Fitting a front CV shaft
A front CV shaft transfers drive from the differential to the wheel hub through joints at each end, and it must allow for both steering angle and suspension travel. On a lifted or re-geared Jeep, the angle of the joints changes, so check that the new shaft and the axle housing suit the setup before buying. Torn boots let grease escape and dirt in, which is the usual cause of joint failure.
Before installing, clean the hub and differential mating surfaces and inspect the axle seal for leaks, since a worn seal can contaminate the new shaft. Many owners replace the boot and axle seal at the same time as the shaft. Check the retaining hardware and use new fasteners where the design calls for them, then recheck tightness after the first drive.
- Inspect the opposite side shaft for boot damage
- Look for grease on the inside of the wheel
- Listen for clicking during tight turns
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 5012456AB |
| UPC | 848399031904 |
| Axle manufacturer | Dana |
| Shaft location | Passenger Side Assembly |
| Axle position | Front |
| Axle type | Dana 30 TJ |
| Position | Front Right |
| Spline count | 27 Splines |
| Design | CV type without Vari-Lok |
Vehicle fitment
Crown Automotive names a single vehicle for the 5012456AB.
- 1999–2004 Jeep Grand Cherokee (WJ) (Laredo, Limited, Overland, Special Edition, Sport)
Only the 1999–2004 Grand Cherokee WJ is covered. The earlier ZJ Grand Cherokee, the XJ Cherokee and the Wranglers use other shafts. Confirm your vehicle’s year, model and trim before ordering.







