Overview
The Bilstein 25-242539 is a 5160 Series reservoir shock absorber for the rear right position, with a lift range of 0 to 1.5 inches. It is a direct fit for the 2005–2018 Toyota Tacoma and installs in the stock shock mounting spot without cutting or welding.
The shock pairs a monotube body with a remote reservoir, giving it more oil capacity and cooling than a single-tube shock. Digressive valving provides full damping right away, and the floating dividing piston in the reservoir supports extra wheel travel. Reservoir mounting is designed for each vehicle application, so the included mounting kit matters.
Key features
- Rear right position with a 0 to 1.5 inch lift range.
- Remote reservoir for added oil capacity and heat dissipation.
- Digressive valving system for immediate full damping capability.
- Floating dividing piston in the reservoir for more shaft movement.
- Reservoir mounting configuration designed for each vehicle application.
- Mono tube body with a 46mm ID smooth body (non-coilover).
- Zinc plated finish from Bilstein’s Triple-C Technology line.
Choosing a rear shock setup
Rear shocks on a pickup carry a large share of the load when the bed is loaded, so matching the pair matters. Replacing one side while the other is worn can leave the truck pulling or riding unevenly. Many owners replace both rear shocks together, then check the bushings and springs at the same time for consistent behavior.
A remote reservoir changes the packaging more than the damping. Pick a reservoir location that keeps the hose clear of the exhaust, the tires and the frame rails. Confirm the mounting kit fits the spot you choose before the old shock comes out, since reservoir placement is the step most likely to slow an install. Gas charged units hold pressure, so wear eye protection and support the axle before loosening the lower mount.
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 25-242539 |
| UPC | 651860756929 |
| Series | 5160 Series |
| Position | Rear right |
| Fitment type | Direct fit |
| Lift range | 0-1.5 in. lift |
| Collapsed length | 14.22 in. |
| Extended length | 24.06 in. |
| Travel length | 9.84 in. |
| Lower mount | Eye 12.1mm |
| Upper mount | Stem |
| Shaft diameter | 14mm |
| Body design | 46mm ID smooth body (non-coilover) |
| Internal design | Mono tube |
| Reservoir | Yes |
| Gas charged | Yes |
| Finish | Zinc plated |
| Boot included | No |
| Mounting parts included | Upper mount kit and reservoir mount kit |
Vehicle fitment
It fits the rear right position of the 2005–2018 Toyota Tacoma in the Base, Limited, Pre Runner, SR, SR5, TRD Off-Road, TRD Pro, TRD Sport and X-Runner trims. Years outside 2005 to 2018 are not covered.
Other Tacoma model years and the left rear position are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The reservoir uses its own mounting kit, so choose and clear the reservoir location before installing. The upper mount kit and reservoir mount kit are included, and the detailed instructions cover the mount sequence. Gas-charged shocks are under pressure, so wear eye protection when removing the old shock.
What’s included
The kit includes an upper mount kit, a reservoir mount kit and detailed instructions.
Not included: The boot is not included with this shock.









