Overview
The Bilstein 33-187471 is a 5100 Series rear shock absorber with a monotube gas pressure design, a 46mm smooth body and a 14mm shaft. It is intended for lifted trucks, Jeeps and prerunners, and no vehicle fitment is confirmed, so verify your vehicle before using it.
The 5100 Series uses a single tube, high gas pressure design aimed at steady damping and long service life. It is made for specific lift kits that keep the stock O.E.M. mounting configuration. In a monotube shock, the oil and gas charge share one tube, with a piston separating them.
Key features
- Monotube gas pressure construction.
- Self-adjusting deflecting disc valving.
- High-flow piston that Bilstein says reduces harshness.
- Independent rebound and compression tuning.
- Larger working piston area for exact damping.
- Bilstein lists superior control for large diameter tires.
- Boot included.
Matching a shock to your lift
When a truck or Jeep is lifted, the shock must reach farther to cover the new suspension geometry. Shocks used with a lift are often pushed toward their limits of travel, so the collapsed and extended lengths matter as much as the damping rate. Measuring the installed distance at both ends before buying prevents a shock that bottoms out or binds at full droop.
Lift kits change the angle of the control arms and the position of the mounts, which can affect how the shock moves. Stock mounting points are simpler to fit, while custom brackets need careful checking for clearance against tires, brake lines and the frame. Replacing worn bushings during the same job keeps the shock traveling in a straight line.
Follow up after installation by driving a short loop, then recheck the mounts and listen for contact noises at full compression.
- Measure installed length at both ends
- Check tire and brake line clearance
- Replace worn suspension bushings with the shock
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 33-187471 |
| UPC | 651860639307 |
| Shock series | 5100 Series |
| Position | Rear |
| Fitment | Direct fit |
| Lift height | w/0 – 1 in. Lift |
| Hydraulic / gas charged | Gas charged |
| Internal design | Mono tube |
| Body design | 46mm ID smooth body (non-coilover) |
| Collapsed length | 17.07 in |
| Extended length | 28.03 in |
| Travel length | 10.96 in |
| Lower mount | Eye 12mm |
| Upper mount | Eye 12mm |
| Shaft diameter | 14mm |
| Reservoir | No |
| Finish | Zinc plated |
| Boot included | Yes |
Vehicle fitment
It is designed for specific lift kits that keep the stock O.E.M. mounting configuration. Identify the matching lift kit or vehicle by year, model and trim before ordering.
Do not assume a fit from the Jeep or truck category alone. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Lift height is rated w/0 – 1 in. Lift, so check that range against your current suspension before installing. With a 28.03 in extended length and 17.07 in collapsed length, confirm clearance at both ends of travel. Support the vehicle safely and check that the 12mm eye mounts line up with the stock mounting points before tightening.
What’s included
Shock absorber with boot included.
Not included: Check the package contents against your installation, including mounting hardware, before starting.









