Overview
The Bilstein 5100 Series shock absorber, part number 33-187228, is a gas-charged monotube unit with 14.1 mm eye mounts at both ends. It is a direct fit shock, and no specific vehicle, model or year is named for it.
The 5100 Series is a single-tube gas-pressure line aimed at lifted trucks, Jeeps and prerunners. This non-coilover shock has a 46 mm ID smooth body and a 14 mm shaft, and its boot is not included.
Key features
- Monotube gas pressure construction
- Self-adjusting deflecting disc valving
- High-flow piston for reduced harshness
- Independent rebound and compression tuning
- Larger working piston area
- Zinc plated finish
Protecting the shaft seal
The shaft seal is the main barrier between the damping components and road grit, so a shock with no boot needs more attention to the shaft during installation. Wipe the shaft clean before fitting, and avoid scratches that can tear the seal. A reused boot should be checked for splits, since a small tear lets dust work into the seal and shorten service life.
Eye mounts at both ends depend on clean, straight bushings. Check that the bushings sit flat in the eye and are not cracked or flattened, because a tight fit at the eye can make the shock feel harsh over small bumps. Replace bushings that show wear while the shock is out, since reaching them later takes extra work.
- Wipe the shaft before installing
- Inspect any reused boot for splits
- Replace cracked bushings during the job
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 33-187228 |
| UPC | 651860656892 |
| Series | 5100 Series |
| Collapsed length | 20.37 in. |
| Extended length | 31.93 in. |
| Travel length | 11.56 in. |
| Lower mount | Eye, 14.1 mm |
| Upper mount | Eye, 14.1 mm |
| Shaft diameter | 14 mm |
| Body design | 46 mm ID smooth body (non-coilover) |
| Internal design | Mono tube |
| Reservoir | No |
| Boot included | No |
| Gas charged | Yes |
| Finish | Zinc plated |
| Fitment type | Direct fit |
Vehicle fitment
No vehicle, model or year is named for this part number. Match the year, model and trim to your truck before buying.
Compare your current shock’s collapsed length of 20.37 in. and extended length of 31.93 in. with the old unit before deciding. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The boot is not included, so reuse your existing boot if it is in good condition or plan for a separate one. Both 14.1 mm eyes should be checked against your existing brackets before fitting.
What’s included
One shock absorber. The boot is not included.









