Overview
The Bilstein 5100 Series 24-185660 is a rear gas-charged monotube shock absorber for the 1987–1995 Jeep Wrangler (YJ). It uses eye mounts at both ends, a 12.7mm lower eye and a 16mm upper eye, with a 14mm shaft inside a 46mm smooth, non-coilover body.
Collapsed length is 14.63 in, extended length is 23.68 in and travel is 9.05 in. The spec sheet pairs this unit with a 3 to 4 in. lift, so compare that figure with the lift on your Wrangler before choosing it.
Key features
- Monotube gas pressure construction
- Disc valving that adjusts itself during travel
- High-flow piston that Bilstein says eases harshness
- Rebound and compression tuned separately
- Bigger piston working area for controlled damping
- Boot included to cover the shaft
Eye mounts and rear travel
Eye-to-eye rear shocks are simple to fit, but they rely on their bushings to control noise and movement. On a Wrangler YJ, the rear shock manages axle wrap and helps keep the tires in contact over ruts. A lift can change the angle of both eyes, so the bushings take more load than they did at stock height.
Rear shocks wear gradually, so the change in ride is easy to miss. Compare the new unit with the old one for travel and mount fit before installing. When one rear shock is replaced, check the other side too, since uneven damping can pull the vehicle sideways on rough ground.
- Check each eye bushing for cracking or play
- Watch for fluid on the body after hard trail use
- Compare the new and old units for travel before fitting
- Replace rear shocks in pairs
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-185660 |
| UPC | 651860608396 |
| Series | 5100 Series |
| Position | Rear |
| Collapsed length | 14.63 in |
| Extended length | 23.68 in |
| Travel length | 9.05 in |
| Lower mount | Eye, 12.7mm |
| Upper mount | Eye, 16mm |
| Shaft diameter | 14mm |
| Body design | 46mm ID smooth body, non-coilover |
| Internal design | Mono tube |
| Gas charged | Yes |
| Reservoir | No |
| Finish | Zinc plated |
| Lift | 3 – 4 in. Lift |
| Fitment type | Direct Fit |
Vehicle fitment
It fits the 1987–1995 Jeep Wrangler (YJ) in Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims. Later Wrangler generations are not covered.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Match the 12.7mm lower eye and 16mm upper eye against the hardware on your vehicle before fitting. Because both ends are eyes, the shock must line up with the rear mounting points without forcing it into place.
What’s included
One rear shock absorber with boot is included. Mounting hardware is not included.









