Overview
The Bilstein 5100 Series rear shock absorber, part number 33-236964, is a 46mm monotube shock for lifted trucks and SUVs. It is a direct fit with a lift height of w/3 – 5 in. Lift. Confirm the vehicle year, model and trim before buying, since fit depends on them.
The 5100 Series is a direct fit solution for lifted vehicles, and each shock in the line is tuned for its specific application. This model has a smooth body, non-coilover design with no reservoir, and its collapsed and extended lengths are 20.28 in. and 32.01 in.
Key features
- Monotube design for consistent, fade-free performance.
- Velocity sensitive, digressive piston that responds to changing road conditions
- Tuned for each application
- Smooth body, non-coilover, with no reservoir
- Zinc plated finish
Lifted truck shock selection
Lifted trucks change the geometry of the suspension, so a shock that works at stock height may run out of travel. Longer travel gives the axle room to articulate on uneven ground, while controlled damping keeps the body from pitching on the highway. Many owners pair shock changes with new tires or steering parts when they raise the truck.
Start by measuring the installed height and comparing it with the collapsed and extended lengths. Confirm the lift range is correct, since a shock used outside its rated range can bottom out or overextend. Inspect mounts and bushings during installation, and recheck fasteners after the first drives on rough roads.
- Measure installed height before ordering
- Check travel needs for trail use
- Match mounts to existing hardware
- Recheck fasteners after rough drives
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 33-236964 |
| UPC | 651860735177 |
| Shock series | 5100 Series |
| Position | Rear |
| Fitment type | Direct Fit |
| Lift height | w/3 – 5 in. Lift |
| Collapsed length | 20.28 in. (515 mm) |
| Extended length | 32.01 in. (813 mm) |
| Body diameter | 46mm |
| Body design | Smooth body (non-coilover) |
| Reservoir | No |
| Finish | Zinc plated |
| Hydraulic / gas charged | Gas charged |
Vehicle fitment
Fit depends on your year, model and trim, so match them before ordering. Check the lift range and the shock’s length against your suspension.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm your lift falls within the w/3 – 5 in. range before choosing this shock, and check the collapsed and extended measurements against your installed suspension.
What’s included
One rear shock absorber, part number 33-236964, is included. Plan for mounting hardware, checking it against your installation before starting.









