Overview
The Baer Brakes 6929207 is a right-side, one-piece replacement brake rotor with a slotted, drilled and zinc-plated surface. It measures 12.44 inches across and 0.477 inch thick, with five bolt holes on a 5-inch circle. It is a service part for select Baer Brake systems.
This rotor is a non-vented, full cast design with drum in hat construction, meaning the drum section is built into the rotor body. It is directional and marked for the right side, so it must be installed only on that side. The slots and drilled holes are part of the surface finish. Confirm the bolt pattern, center hole and hub dimensions against your vehicle before ordering.
Key features
- One-piece full cast construction
- Slotted and drilled braking surface
- Zinc-plated finish
- Drum in hat design
- Curved vane design for optimum cooling
- Dynamic balanced for vibration-free performance
- Performance grade type with cast iron material
Drum in hat basics
A drum in hat rotor combines a disc friction surface with an inner drum that works as the parking brake drum. The drum section sits inside the rotor body, so the hub and the parking brake shoes must clear it. Before fitting, check the hub face, the parking brake adjuster and the shoe position, because interference there can stop the rotor from seating flat against the hub.
Non-vented solid discs rely on mass to absorb heat, so they suit lighter use better than long downhill runs. Keep the surface clean and avoid grease on the friction face. When replacing, inspect the bearing seals, wheel studs and caliper bracket for wear. Bed in new pads gradually so an even layer of friction material transfers to the disc.
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6929207 |
| UPC | 844165051107 |
| Axle position | Right |
| Construction | Full cast, one piece |
| Material | Cast iron |
| Surface type | Slotted, drilled and zinc plated |
| Solid or vented | Non-vented |
| Brake surface | Directional |
| Drum in hat | Yes |
| Outside diameter | 12.44 inches |
| Nominal thickness | 0.477 inch |
| Overall height | 3.01 inches |
| Center hole diameter | 2.84 inches |
| Stud/lug hole quantity | 5 |
| Stud/lug hole circle diameter | 5 inches |
| Grade type | Performance |
| Emission code | 6 |
| ABS tone ring included | No |
| Sold as | Each |
| Country of origin | USA |
Vehicle fitment
Match this rotor to a compatible Baer brake system and hub before buying, since it is built for select systems.
Confirm your vehicle’s year, model and trim before ordering. The right-side-only design means a left-side hub will not use this rotor.
Installation notes
Check the 2.84-inch center hole and 3.01-inch overall height against your hub before fitting, since the drum in hat design sits within the rotor body. The rotor must go on the right side. Brake work is safety-critical, so have a qualified technician verify clearance and seating before the vehicle returns to the road.
What’s included
One right-side, one-piece rotor with the slotted, drilled and zinc-plated surface.
Not included: brake pads, calipers, hub hardware and the ABS tone ring.
