Overview
The Crown Automotive 52006472 is a front brake hose for the passenger side of the 1990–1995 Jeep Wrangler (YJ) without anti-lock brakes. The hose comes with the frame mounting bracket attached.
Key features
- Passenger side only
- For 1990–1995 YJ without anti-lock brakes
- Frame mounting bracket attached to the hose
- 3/8 inside diameter hole in the caliper end
- Rubber, stock length
Front brake hose service
A front brake hose flexes with the steering and suspension on every bump, so it ages faster at the bends near the frame bracket. Look for cracks in the outer cover, swelling under pressure, and wet spots at the caliper fitting. Any of these means the hose should be replaced before it fails under braking.
Replacing the hose opens the line, so air can enter the system. Keep the reservoir topped up and bleed the caliper until the fluid runs clear of bubbles. Check that the hose does not touch the tire or the steering components when the wheel turns fully.
- Look for cracks near the bracket
- Keep the reservoir topped up while bleeding
- Confirm the hose clears the tire at full steering lock
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52006472 |
| UPC | 848399013795 |
| Position | Front right (passenger side) |
| Type | Rubber |
| Hose length | 20 |
| Caliper end hole | 3/8 inside diameter |
| Length class | Stock |
| Brake system | Without anti-lock brakes |
Vehicle fitment
It fits the 1990–1995 Jeep Wrangler (YJ) without anti-lock brakes, on the passenger side only.
A YJ with anti-lock brakes is not covered, and the hose does not fit the driver side. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The frame mounting bracket is already attached to the hose, so it is a straight swap at the passenger side front wheel followed by a brake bleed.
What’s included
Front brake hose with the frame mounting bracket attached.











