Overview
The Baer Brakes 6800501 is a 21.5-inch braided brake hose set that pairs a 3AN female straight end with a 10 mm banjo end set at 20 degrees. Baer packages the set as two hoses and says each one attaches directly to an OE hard line.
The hoses use steel braiding over a stainless steel hose material, along with a Teflon liner that Baer describes as preventing expansion for a consistent pedal feel. Baer designed the set for high-performance and precision braking work, and the hoses carry a DOT approved rating.
Key features
- Stainless steel hose material with steel braiding.
- Teflon liner to limit expansion and keep pedal feel consistent.
- DOT approved.
- Attaches directly to an OE hard line.
- Packaged as a pair of hoses.
- End 1: -3 AN fitting, 3AN female straight, 3/8-24 inch UNJF thread.
- End 2: banjo fitting at 20 degrees with a 10 mm banjo bolt hex.
- 21.5-inch hose length.
Before you buy
A brake hose carries fluid between a fixed hard line and the moving wheel assembly, so it must allow for suspension travel and steering movement without being pulled taut. Before buying, compare the banjo end angle and fitting type against the caliper or hard line you are replacing. Braided construction resists swelling under pressure, which helps keep pedal feel steady, but it does not change the fitting geometry.
Brake hoses are commonly replaced in pairs on the same axle so the two sides respond alike. Replacing a hose also gives a good moment to inspect the hard lines, brackets and rubber sections nearby for chafing or corrosion. Keep the old hose until the new one is confirmed to clear the parts around it.
- Compare the fitting type at both ends with the old hose
- Look for clearance at full steering lock and suspension travel
- Use new crush washers at each banjo connection
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6800501 |
| UPC | 90127990643 |
| Hose length | 21.5 inches |
| End 1 fitting | -3 AN, 3AN female straight |
| End 1 thread | 3/8-24 inch UNJF |
| End 2 fitting | Banjo, 20 degrees |
| Banjo bolt hex size | 10 mm |
| Hose material | Stainless steel, steel braided |
| Fitting material | Steel |
| Grade type | Performance |
| Pack format | Set of two hoses, packaged as a pair |
| Crush washers included | No |
| Bracket attached | No, neither hose |
| Emission code | 6 |
| Country of origin | USA |
Vehicle fitment
Do not match the 21.5-inch length to a vehicle by eye. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Supply new crush washers for the banjo connections, since none come with the set. Neither hose is bracket attached, so the set relies on the existing OE hard line for support. Brake lines are safety-critical, so bleed the system and test the pedal before driving.
What’s included
Two braided hoses come in this set, packaged as a pair.
Not included: crush washers.













