Overview
The Auburn Gear 545013 is an ECTED Max selectable locker for Dana 35 axles with 27 splines, made for 3.55 and up gear ratios. It combines a full-time limited slip with a full locking differential that an in-vehicle switch activates. The change can be made on the fly at moderate speeds.
The unit is named for front and rear axle location. Match the Dana 35 axle, spline count and gear ratio to your setup before fitting, since no vehicle year or model is given.
Key features
- Full-time limited slip with full lock on demand
- In-vehicle switch engages the locking mode
- Changes on the fly at moderate speeds.
- 27 spline axle count
- Designed for 3.55 and up gear ratios.
Before you buy
Gear ratio drives whether a selectable locker is a good fit. A locker built for 3.55 and up gears suits axles that already carry a numerically higher ratio, and a shop should confirm the ring gear and pinion before the unit goes in. Mixing a locker with the wrong ratio can make the axle noisy and shorten gear life.
Dana 35 axles are common on lighter trucks and utility builds, so the locker is usually a choice for off-road traction or towing confidence. Before buying, decide whether the cab switch, wiring and any indicator will suit your layout, since the switch circuit is the part most often left until the end.
- Check the existing ring gear ratio
- Plan the cab switch location
- Consider fresh carrier bearings if the axle is high mileage
Specifications
| Brand | Auburn Gear |
|---|---|
| Part number | 545013 |
| UPC | 814996006133 |
| Differential type | Selectable locker (ECTED Max) |
| Locking mode | Full lock via in-vehicle switch |
| Axle manufacturer | Dana |
| Axle type | Dana 35 |
| Axle location | Front or rear |
| Axle spline | 27 splines |
| Gear ratio | 3.55 and up |
Vehicle fitment
It fits Dana 35 axles with 27 splines, in front or rear location, for 3.55 and up gears. Confirm fit for your vehicle’s year, model and trim before ordering.
Only the Dana 35 axle type is named, so other Dana axle families are outside this fit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Selectable lockers need an in-vehicle switch circuit, which the installer must plan for. Gear setup and bearing preload must suit a 3.55 or numerically higher ratio, and the clutch should be broken in before hard use.
What’s included
No switch, wiring or hardware is named as included. Check the kit contents before installing.









