Overview
The Auburn Gear 545014 is an ECTED Max selectable locker for Dana 35 rear axles with 30 splines, made for use with 3.31 and down gears. It runs as a full-time limited slip and switches to a full locking differential on the fly at moderate speeds.
The unit runs as a limited slip until full lock is selected. Confirm fit for your vehicle’s year, model and trim before ordering, since the axle type and spline count are the match points.
Key features
- Full-time limited slip with full lock on switch
- Shifts from limited slip to full spool on the fly
- Smooth street operation.
- For 30 spline Dana 35 rear axles
- For 3.31 and down gears
- 4 year replacement warranty
Care and maintenance
Lockers rely on the clutch pack staying in good condition, so keep the differential fluid at the correct level and change it on schedule. If you run a friction modifier, choose one suited to the oil type in the axle. Note any chatter on tight turns, since that can point to clutch wear.
Inspect the axle seals, pinion seal and vent for leaks after the first few trail runs, and re-check bolts on the cover and any mounts. A rear axle used for towing or heavy loads should be checked more often than one used for daily driving. Keep a service log so you can spot changes in noise or behavior over time.
- Check fluid level and condition regularly
- Look for leaks at seals and the cover
- Listen for chatter on tight turns
Specifications
| Brand | Auburn Gear |
|---|---|
| Part number | 545014 |
| UPC | 814996006140 |
| Differential type | Selectable locker (ECTED Max) |
| Activation | In-vehicle switch |
| Axle manufacturer | Dana |
| Axle type | Dana 35 |
| Axle location | Rear |
| Axle spline | 30 splines |
| Gear ratio | 3.31 and down |
| Warranty | 4 year replacement warranty |
Vehicle fitment
Fitment is given by axle type: Dana 35 rear axles with 30 splines, for 3.31 and down gears. Fitment is not confirmed for any particular vehicle.
Only the rear location is named, so front axle use is not covered by this fit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installing it means adding an in-vehicle switch circuit, which must be planned before the axle goes back together. Set backlash and bearing preload for a 3.31 or lower ratio, and allow a break-in period before heavy use.
What’s included
Check the package contents for a switch, wiring and any hardware before installing.









