Overview
The Auburn Gear 5420118 is a Pro Series limited slip differential assembly for the GM 12 bolt rear axle, 8.875 inch size, with 33 splines and a 3.07 to 3.73 ratio range.
The Pro Series is designed to be aggressive while staying streetable. It uses a preloaded cone clutch system with a higher preload rating, and it carries a 4 year replacement D-REX program.
Key features
- Very aggressive limited slip action that the brand describes as still streetable
- Preloaded cone clutch system with a much higher preload rating
- 33 spline rear axle connection
- Listed ratio range of 3.07 to 3.73
- 4 year replacement D-REX program from Auburn Gear
Limited slip break-in and setup
A limited slip differential uses clutches to send torque to both wheels, so its behavior changes with the fluid, the preload and the clutch wear. Use a gear oil that is made for limited slip units, and fill it to the level the axle calls for. Most units need a break-in period before full loading.
Ring and pinion setup, bearing preload and pinion depth matter as much as the differential itself, so a qualified driveline shop should check them when installing. Replace the axle seals and check the bearings if the housing is opened. Recheck the fluid level after the first drives and listen for chatter during turns.
Frequent hard launches and large tires can accelerate clutch wear, so inspect the unit if you notice slipping, chatter or a change in feel.
Specifications
| Brand | Auburn Gear |
|---|---|
| Part number | 5420118 |
| UPC | 70000259717 |
| Product line | Pro Series |
| Axle manufacturer | GM |
| Axle location | Rear |
| Axle type | GM 12 bolt, 8.875 inches |
| Axle spline | 33 splines |
| Differential type | Limited slip assembly |
| Ratio range | 3.07 – 3.73 |
Vehicle fitment
It is an axle-type unit for a GM 12 bolt rear axle at 8.875 inches with 33 splines. Confirm the year, make, model and trim of your vehicle before ordering, since no vehicle is named.
An axle with a different spline count or housing size will not match this unit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 33 spline count must match your axle shafts, and the housing has to be the 8.875 inch GM 12 bolt design. Use a qualified driveline shop to measure and install the unit.
What’s included
It is a complete limited slip differential assembly with no other hardware named. Check the package contents against your installation before starting.










