Overview
The Auburn Gear 545016 is an ECTED Max selectable locker for the front Dana 30 axle with 27 splines, made for 3.54 and down gear ratios. It runs as a full-time limited slip and changes to a full lock with an in-vehicle switch, shifting on the fly at moderate speeds.
Four Dana 30 axle variants are named: Reverse, TJ, Standard and JK. Compare your axle build against those variants before fitting, because no vehicle year or chassis is named with them.
Key features
- Full-time limited slip operation
- Switch-activated full lock
- Changes on the fly at moderate speeds.
- 27 spline front axle
- Made for 3.54 and down gears.
Front axle considerations
Front axles carry steering and drive loads, so a front locker changes how the vehicle handles tight turns and low-speed traction. Dana 30 variants differ in build, so the axle shop should confirm which variant is under the vehicle before selecting a locker. Many builders also upgrade the front axle shafts and seals while the axle is open.
Choosing a front locker often comes down to how much low-speed control you want on uneven ground. Plan the switch circuit so the driver can use it easily, and confirm the steering components have room to clear the axle. Before fitting, measure the gear ratio and check the carrier bearings and ring gear wear.
- Confirm the axle variant before buying
- Check steering clearance with the locker fitted
- Inspect front axle shafts and seals while open
Specifications
| Brand | Auburn Gear |
|---|---|
| Part number | 545016 |
| UPC | 814996006164 |
| Differential type | Selectable locker (ECTED Max) |
| Locking mode | Full lock via in-vehicle switch |
| Axle manufacturer | Dana |
| Axle type | Dana 30 Reverse, Dana 30 TJ, Dana 30 Standard, Dana 30 JK |
| Axle location | Front |
| Axle spline | 27 splines |
| Gear ratio | 3.54 and down |
Vehicle fitment
Fitment is given by Dana 30 axle variant rather than by vehicle: Reverse, TJ, Standard and JK, with 27 splines at the front, for 3.54 and down gears.
The Dana 30 Reverse, TJ, Standard and JK variants are the axle types covered. Other axle families are outside this fit, so confirm your vehicle’s year, model and trim before ordering.
Installation notes
Setting up a selectable locker means matching carrier backlash and bearing preload to a 3.54 or lower ratio, which suits an axle shop. The switch needs its own circuit from the cab. Break in the clutch before heavy use.
What’s included
Check the package contents for a switch, wiring and other parts before installing.









