Overview
The Auburn Gear 542072 is an H/P Series limited slip differential assembly for a Chrysler 8.25 inch rear axle with 27 splines. It uses a preloaded tapered cone type clutch, and the axle location is rear.
The H/P line is built for both on road and off road driving. The unit comes with a 4 year replacement D-REX program.
Key features
- Preloaded tapered cone type clutch
- H/P Series limited slip design
- Complete limited slip differential assembly
- Chrysler 8.25 inch rear axle with 27 splines
- 4 year replacement D-REX program
Preload and break-in care
The H/P Series uses a preloaded tapered cone type clutch, which holds the clutch plates under light pressure before any torque is applied. This gives the rear wheels a more even share of power on loose surfaces, and it can feel firmer during slow turns on pavement. Because the setup affects how the unit grips, the preload is best checked by a shop once the carrier is in place.
Break-in matters for a new clutch pack. During the first stretch of driving, keep throttle steady and avoid repeated wheel spin, so the plates and gear faces settle together. Afterward, check the rear cover for leaks and confirm the gear oil level, since low fluid is one of the most common reasons a limited slip unit starts to chatter.
- Confirm the 27 spline count before ordering
- Check the rear cover for leaks after the first trips
- Recheck fluid level after the break-in period
Specifications
| Brand | Auburn Gear |
|---|---|
| Part number | 542072 |
| UPC | 81499600072 |
| Series | H/P Series |
| Differential type | Limited slip assembly |
| Clutch system | Preloaded tapered cone type |
| Axle manufacturer | Chrysler |
| Axle location | Rear |
| Axle type | Chrysler 8.25 inches |
| Axle spline count | 27 splines |
Vehicle fitment
Universal fit is listed, but the unit is made for a Chrysler 8.25 inch rear axle with 27 splines. Check those specs against your axle before you order, since no vehicle years, models or trims are named.
A 29 spline Chrysler 8.25 inch H/P unit (542074) is a separate part number. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The unit replaces the existing rear differential as a complete assembly. Confirm the 27 spline count on your axle shafts first, then have a shop with limited slip experience set the preload and run the unit in.
What’s included
The package is a complete limited slip differential assembly. Gaskets, bearings and fasteners may be needed, so check them against your installation before starting.










