Overview
The Artec Industries TB1009 is a set of coilover tabs for truss, meant to carry shocks or coilovers near the very ends of a front Dana 60 truss. Artec says mounting them there adds stability, and the tabs bridge the gap between the inner “c” and the truss to reinforce the whole axle against bending or breaking.
The tabs are CNC cut from 1/4 inch thick mild steel and include four pieces, enough for two shocks. The manufacturer intends them for its front Dana 60 truss system, so the axle type matters more than the vehicle.
Key features
- CNC cut from 1/4 inch thick mild steel
- 1/2 inch hole common to most shocks
- Holes intended to be mounted 1.25 inches apart
- Four pieces for use with two shocks
- Bridges the inner “c” and the truss to reinforce the axle
Front axle reinforcement
Tabs placed near the ends of an axle tube and truss help resist the bending that comes from shock and spring loads. Moving the shock mount outward changes the leverage on the axle, so the tabs carry more of the stress than a shock mounted closer to the center. Good weld penetration at both the inner c and the truss is what turns the tab into real reinforcement.
Front axles see steering, braking and articulation loads together, so inspect the tabs and welds on a regular schedule. Look for cracked welds, bent truss sections and shock mounts that have started to wander. Shocks that bind or wear unevenly often point to a bent mount, so check alignment before blaming the shock.
- Inspect the inner c and truss welds after hard use
- Check shock mount alignment before fitting new shocks
- Look for bending near the spring and shock mounts
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | TB1009 |
| UPC | 816791023582 |
| Material | Mild steel, 1/4″ thick, CNC cut |
| Shock hole size | 1/2″ |
| Hole spacing | 1.25″ apart |
| Quantity | Four pieces, for two shocks |
| Axle type | Dana 60 |
| Axle location | Front |
| Steering ram mount | Without steering ram mount |
Vehicle fitment
These tabs are universal fit, but they are built for a front Dana 60 truss. Dana 60 is an axle name, not a vehicle, so compare your axle and truss layout before fitting them.
The tabs are built for a front Dana 60 truss, and no rear Dana 60 or other axle type applies. Before ordering, confirm fit for your vehicle’s year, model and trim.
Installation notes
Check that the 1/2 inch holes line up with your shock mounts at 1.25 inches apart before fixing the tabs. Because they sit between the inner “c” and the truss, plan the weld placement around that spacing.
What’s included
Four tabs, enough for two shocks.
Not included: Shocks, coilovers and mounting hardware are not included.












