Overview
The Artec BR1017 is an inner frame bracket for control arm mounting, sold under part number BR1017 by Artec Industries. It takes a cartridge joint with a 2.625 inch mounting width and a 9/16 inch bolt hole, the size used by common cartridge joints such as Johnny, Flex and Ballistic. It is a formed bracket rather than a modified length of angle iron or C-channel.
The design aims at the usual weak points of frame brackets. Grease fitting access sits on top, the joint can be mounted grease fitting up, and a skid plate protects the joint from below. Artec says other frame brackets mount the fitting down, where a rock strike can break it, and this layout avoids that problem.
Key features
- Top grease fitting access makes routine greasing of the most worn joint easier.
- Joint can be mounted grease fitting up, avoiding the fitting-down layout that Artec says breaks fittings on impact.
- Bottom skid plate wraps the joint for direct impact protection and less premature wear.
- Skid plate does not restrict joint movement.
- Tapered sides allow mounting at an angle on the frame without excess bracket hanging off the side.
- 2.625 inch mounting width and 9/16 inch bolt hole fit common sized Cartridge Joints.
- Hole can be drilled out for 1.25 inch rod ends used with spacers.
- Formed from 1/4 inch thick boxed steel plate for strength and impact resistance.
Dry fit and angle setup
An inner frame bracket sits between the frame and the joint, so its position decides how the control arm loads the frame. Setting the bracket at the right angle before final mounting keeps the joint working inside its range and avoids binding at full articulation.
Dry fitting is the most useful step. Place the bracket at the angle you plan to run, check the joint’s grease fitting for access, and cycle the suspension to confirm nothing rubs. Tapered sides help keep the bracket close to the frame, which reduces the chance of rock strikes.
If you drill the hole out for 1.25 inch rod ends, use the spacers the setup requires and deburr the hole before assembly. Recheck the bolts after the first few trail runs, because vibration can loosen hardware on any frame-mounted joint.
- Dry fit before final mounting
- Check grease fitting access after assembly
- Deburr any drilled hole before installing
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | BR1017 |
| UPC | 816791020246 |
| Type | Control arm mount |
| Mounting width | 2.625 inch |
| Bolt hole | 9/16 inch |
| Material | 1/4 inch thick boxed steel plate |
| Tube diameter | Any |
| Sold as | Single |
Vehicle fitment
The bracket is not built for one make or model. Match the 2.625 inch mounting width, the joint size and the frame layout to your build.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Dry fit the bracket at the angle you plan to run before final mounting, since the tapered sides and frame position change how much bracket sits clear of the rocks. The joint must match the 9/16 inch hole, or a drilled 1.25 inch hole with spacers.
What’s included
One bracket, sold as a single.
Not included: cartridge joint and mounting hardware.









