Overview
The Artec Industries HS6152 is a set of crossover high steer arms for 1999–2004 Ford F-250 and F-350 Super Duty trucks. The arms weld onto the Super Duty knuckles and are meant to help eliminate steering problems on swapped front ends.
The arms are configurable and affordable, and they come in three variations so the steering setup can be tuned for the rig.
Key features
- High steer arms for 1999–2004 Ford Super Duty knuckles
- Crossover design
- Weld-on arms
- Three configuration variations
- Aimed at steering problems on swapped axles
Steering geometry on swapped axles
Swapping axles changes the steering geometry, and high steer arms are one way to move the steering linkage up and reduce binding. The arm angle affects how the tie rod moves through its travel, so the choice of variation should be matched to the rig’s lift and axle position. Check steering travel and turning clearance after the setup is in.
Because the arms are weld-on, plan the job with proper weld prep and heat control, and check the knuckle for cracks or damage before welding. Tie rods, drag links and ball joints are often replaced together with new steer arms, since the angles change and worn joints can loosen under the new loads.
After installation, check for bump steer, toe settings and tire clearance at full lock. Re-check welds and linkage fasteners after the first few trail runs, and look for cracking near the weld zone.
- Inspect the knuckle before welding
- Replace worn tie rods and joints at the same time
- Check toe and turning clearance after install
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | HS6152 |
| Part type | Crossover high steer arms |
| Mounting | Weld-on |
| Variations | 3 |
| Fit type | Direct fit |
Vehicle fitment
The HS6152 is a direct fit for the 1999–2004 Ford F-250 and F-350 Super Duty.
The arms are matched to the 1999–2004 Super Duty knuckles; other model years and other Ford trucks are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
These are weld-on arms, so welding to the knuckles is part of the installation.











