Overview
The Artec Front Lower Control Arm Skids, part number JK4404, are bare steel skids for the front lower control arm of the 2007–2016 Jeep Wrangler JK, in two-door and four-door models. They are also numbered A/IJK4404.
The skids are made from 1/4-inch mild steel in a wrap-around design that protects the control arm joints and adds reinforcement to a weak area. They reinforce the front Dana 30 or Dana 44 JK axle lower control arm brackets.
Installation requires welding and general fabrication. Artec recommends removing the upper ball joint before welding. Some grinding and fitment work may be needed, and Artec says every axle varies slightly, so some fabrication may be required.
Key features
- Wrap-around steel design to protect the control arm joints
- 1/4-inch mild steel
- Bare steel finish
- Reinforces the front lower control arm brackets
- Works with Dana 30 or Dana 44 front axles
- Welding required
Preparing the control arm
Lower control arm skids protect the arm and its bushings from contact damage on rocks and uneven ground, and they add material where the arm meets the axle bracket. Because the skid is welded to the arm, the fit depends on how the arm sits on your particular axle, so check clearance at the joint before committing to the weld. Steel skids also add some weight at the front end, which is worth considering for daily driving.
Clean the mating surfaces down to bare metal, and remove the upper ball joint as needed for access. Dry-fit the skids and mark the weld lines, then tack them in place before finish welding. After installation, inspect the welds and the control arm joints after the first few trail runs for cracks, and check the bushings for wear.
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | JK4404 (also numbered A/IJK4404) |
| UPC | 816791021717 |
| Type | Control arm skid |
| Material | 1/4-inch mild steel |
| Finish | Bare steel |
| Quantity | Pair |
| Position | Front lower control arm |
| Axle | Dana 30 or Dana 44 |
| Installation | Welding required |
| Fitment type | Direct fit |
Vehicle fitment
The skids fit the 2007–2016 Jeep Wrangler JK, including the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S, X and Unlimited trims, among others.
This set is for the 2007–2016 Jeep Wrangler JK. Confirm fit for a 2017-and-later Wrangler JL or an earlier generation before ordering.
Installation notes
Welding and general fabrication are required. Remove the upper ball joint before welding, and expect some grinding and fitment work, since every axle varies slightly.
What’s included
A pair of bare steel front lower control arm skids.









