Overview
The Artec Industries BR1022 lower link axle brackets, part BR1022, are control arm mounts made for Ford Dana 60 axles that have only 3 inches of axle tube on one side. They suit builds where a standard lower link joint will not fit on a short axle tube.
The brackets accept a 2.625 inch mounting width with 9/16 inch bolt hole joints. Artec describes them as made specifically for Ford Dana 60 axles with that short tube length.
Key features
- Made for Ford Dana 60 axles with 3 inches of tube on one side
- Accepts 2.625 inch mounting width
- Takes joints with 9/16 inch bolt holes
- Control arm mount type, sold as a pair
Short-tube axle considerations
A lower link carries the axle’s drive and braking forces to the frame, so the mount has to sit where the link can pivot through its full travel without binding. On a short axle tube there is less room to place a bracket, which is why the side with the shorter tube deserves a careful look before any cutting or welding. Mark the bracket position with the axle installed, check clearance to the brake line, driveshaft and spring pack, and confirm the link runs in a clean arc at both ends of travel.
Alignment matters as much as clearance. Once the lower links are in, check the axle’s pinion angle and the angle of each link, since uneven link lengths or mounts can shift the axle under load. Joints wear over time, so inspect the bolt holes and joint ends during routine service and look for play, cracked welds or elongated holes. Replacing worn joints together keeps both sides of the axle working the same way.
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | BR1022 |
| UPC | 816791020277 |
| Type | Control arm mount |
| Tube diameter | 3 inches |
| Mounting width | 2.625 inch |
| Bolt hole size | 9/16 inch |
| Quantity | Pair |
| Fitment | Universal fit |
Vehicle fitment
The brackets are made for Ford Dana 60 axles with only 3 inches of axle tube on one side. Confirm fit for your vehicle’s year, model and trim before ordering.
Measure both axle tubes before ordering, since the bracket is made for the short side. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the joint you plan to use has a 2.625 inch mounting width and 9/16 inch bolt holes before fitting the brackets.
What’s included
A pair of Dana 60 lower link axle brackets.
Not included: lower link joints and bolts.














