Overview
The Artec D60 Knuckle Bolt Kit, part number HS6081, is a bolt, locking nut and sleeve set designed for Artec Ultimate Dana 60 high steer arms. It adds strength to the knuckle and steering at the same time, and it gives you options for mounting the steering, whether you need extra knuckle support or want to run the tie rod in double sheer.
Two kits are needed for a pair of high steer arms. This kit is designed to work with the Artec Dana 60 arms, so confirm the arm and axle match before ordering.
Key features
- Strengthens the knuckle and steering when used with the high steer arm.
- Supports more than one steering configuration, including a tie rod in double sheer.
- Uses a 3/4 inch grade 8 bolt for mounting strength.
- All-steel mechanical locking nut holds the bolt in place.
- Sleeve is cut in half when running a heim in double sheer.
- Works with Artec Ultimate Dana 60 high steer arms.
Preparing the knuckle
Preparing the knuckle is the step that most affects how the kit performs. Drilling the knuckle hole is precision work, so it helps to mark the location carefully, drill it square, and deburr both sides before the sleeve goes in. A slightly off-center hole can make the bolt sit under uneven load, which is hard to notice until the steering starts to feel loose. Clean the bore thoroughly and make sure the sleeve seats fully before assembly.
If you plan to run a heim in double sheer, cut the sleeve in half with a clean, square cut and deburr the ends. Check that the heim moves freely and that the tie rod clears the knuckle through its full travel. After assembly, inspect the joint for any sign of movement and re-check the lock nut after the first few drives. Keep records of what was drilled and when, so future service is easier.
- Mark and drill the knuckle hole square
- Deburr the sleeve and bore before assembly
- Check heim movement and tie rod clearance
- Re-check the lock nut after initial drives
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | HS6081 |
| UPC | 816791021311 |
| Bolt | 3/4 inch grade 8 |
| Locking nut | 3/4 inch all-steel mechanical |
| Sleeve | 1.25 inch outer diameter, .250 inch wall |
| Kits per pair of arms | 2 |
Vehicle fitment
No vehicle list is given for this kit. It is designed for Artec Ultimate Dana 60 high steer arms, so confirm the axle and arm match before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Running a heim in double sheer requires cutting the sleeve in half. The factory knuckle hole must be drilled to 3/4 inch for this kit. Drilling a steering knuckle is precision work, so have it done by a qualified machine shop.
What’s included
One 3/4 inch grade 8 bolt, one 3/4 inch all-steel mechanical locking nut, and one 1.25 inch outer diameter, .250 inch wall sleeve.
Not included: The knuckle and the high steer arm, which are sold separately.














