Overview
The Artec D60 Knuckle Bolt Kit, model HS6080, is a set of parts that strengthens the knuckle and steering on Artec Ultimate Dana 60 high steer arms. Each kit contains one 3/4-16 tpi, 10-inch grade 8 bolt, one 3/4-16 tpi all-steel mechanical lock nut and one machined sleeve.
Use the kit if you need to reinforce the knuckle or want to run the tie rod in double sheer. Each high steer arm needs its own kit, so a pair of arms requires two kits.
The kit can be used in several steering configurations, and the sleeve can be cut in half to run a heim joint in double sheer.
Key features
- 3/4-16 tpi, 10-inch grade 8 bolt
- 3/4-16 tpi all-steel mechanical lock nut
- Machined 1.25-inch OD, .250-inch wall DOM sleeve
- Supports double sheer tie rod setups when the sleeve is cut in half
- Strengthens the knuckle and steering
Knuckle strength and steering geometry
A high steer arm transfers steering load into the knuckle, so the bolt and lock nut at that joint carry significant force, especially with larger tires and steering stops set aside. A reinforcing kit like this one is about keeping that joint tight and stable under load. Running the tie rod in double sheer changes how the force is shared, so the setup should be checked after installation for smooth movement and no binding.
Care after installation is mostly about inspection. Check the lock nut and bolt after the first few drives and again after hard off-road use. Look for play at the knuckle, witness marks around the sleeve, and any heim movement that suggests the joint is loosening. Lubricate moving parts as recommended for the joint type, and keep the steering stops and tie rod clear of contact. Any hole that needs drilling should be checked for alignment before the parts go together.
- Re-check the lock nut after the first few drives
- Look for play at the knuckle and heim joint
- Confirm the tie rod moves freely through its range
- Keep steering stops and tie rod clear of contact
Specifications
| Brand | Artec Industries |
|---|---|
| Model | HS6080 |
| Bolt | 3/4-16 tpi, 10-inch, grade 8 |
| Lock nut | 3/4-16 tpi, all-steel mechanical |
| Sleeve | 1.25-inch OD, .250-inch wall DOM |
| Packaging | Individual kit |
| UPC | 816791021304 |
Vehicle fitment
No vehicle fitment is given for this kit. It is built for Artec Ultimate Dana 60 high steer arms and Dana 60 knuckles, so match it to those parts rather than to a vehicle. This kit is built around Dana 60 knuckles.
Confirm your axle and knuckle match this kit before fitting, and confirm the year, model and trim of your vehicle before ordering.
Installation notes
The factory knuckle hole needs to be drilled to 3/4-inch to accept this kit. If you run the tie rod in double sheer, the sleeve must be cut in half first.
What’s included
Each kit includes one 3/4-inch grade 8 bolt, one all-steel mechanical lock nut and one 1.25-inch OD sleeve.
Not included: the knuckle and the high steer arm, which are available separately.












