Overview
The Artec Industries HS4402-2 is a Dana 44 high steer arm kit with two long arms, built for crossover steering and full hydro steering setups. The arms allow the steering links to attach at different locations and points on the knuckle.
Artec built the kit with both long arms because many vehicles use a tie rod in front and a drag link behind. When paired with the optional Dana 44 Knuckle Bolt Kit, the arms are meant to increase overall knuckle and steering strength.
Key features
- Two long arms for a tie rod in front and a drag link behind
- Attachment options for the steering links by location and attachment point
- Designed to pair with the optional Dana 44 Knuckle Bolt Kit
- Suits crossover steering and full hydro steering setups
- Studs, cone washers and nuts are offered as options
Steering link setup
High steer arms move the steering link attachment above the axle centerline, which changes how the steering geometry works during turns and articulation. The long arms in this kit let you choose the attachment location, so the links can be set to suit a tie rod in front and a drag link behind. Set the arms with the steering geometry in mind, and recheck toe after the setup is complete.
Using a knuckle bolt kit alongside the arms helps reinforce the knuckle, which is useful where steering loads are heavier. Before installing, check wheel clearance, the passenger knuckle machining and the bolt pattern, since these affect whether the arms seat properly. Watch for loose links or uneven tire wear after any steering change.
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | HS4402-2 |
| UPC | 816791021168 |
| Axle | Dana 44 |
| Arm style | Long arms, high steer |
| Studs, cone washers and nuts | Optional |
Vehicle fitment
Fit depends on the Dana 44 knuckle and spindle assembly in use. Confirm your vehicle’s year, model and trim before ordering.
Some Dana 44 knuckle and spindle assemblies lack the wheel clearance for high steer arms, and most passenger side knuckles are not drilled and tapped for them. Verify your year, model and trim before ordering. Measure your axle before buying.
Installation notes
Wheel spacers may be required with these or any other Dana 44 high steer arms, because of clearance with the wheel. Passenger side knuckles need a flat surface and machining in the exact mirror image of the driver side, duplicating the bolt pattern and its angle relative to the ball joint. If that is not machined correctly, the Knuckle Bolt Kit may not align properly on the passenger side.
Have the alignment checked after any steering change.
What’s included
The kit includes the high steer arms with both long arms.
Studs, cone washers and nuts are optional.
Not included: The Dana 44 Knuckle Bolt Kit, which is available separately. It comes with a 3/4″ grade 8 bolt, a 3/4″ all-steel mechanical locking nut, a 1.25″ outer diameter sleeve and a knuckle specific bracket.












